The crankshaft position sensor (CKP) on a 2010 Honda Accord is located in different spots depending on the engine. For the 2.4-liter four-cylinder, it sits on the front of the engine block near the timing cover. For the 3.5-liter V6, it’s mounted on the side of the engine block near the transmission bell housing. This guide outlines the two common locations and how to identify them.
Engine variants and sensor locations
Below are the two typical CKP sensor placements you’ll encounter on the 2010 Accord, based on the engine option.
- 2.4L four-cylinder (K-series): Front of the engine block, near the timing cover, with the electrical connector pointing toward the front of the car. Access is usually from the top of the engine bay or the passenger-side area near the radiator support.
- 3.5L V6 (J-series): Side of the engine block near the transmission bell housing; the sensor sits lower in the engine bay and the wiring harness runs toward the back of the engine toward the firewall.
Locations can vary slightly by trim and production date, so if you’re unsure, consult the vehicle’s service manual or a VIN-specific diagram to confirm the exact sensor location.
2.4L I4 (K-series) location details
For the 2.4L Accord, begin by inspecting the front of the engine block where the timing chain/cover sits. The CKP sensor is mounted to the block close to this area and faces the crankshaft to read its position via a reluctor wheel. The connector usually features two or three wires and runs along the front of the engine toward the wiring harness. Depending on the model year, you may access it from above the engine or from the passenger side near the radiator support.
3.5L V6 (J-series) location details
In the 3.5L V6, look along the side of the engine block near the bell housing that attaches to the transmission. The CKP sensor is typically lower in the engine bay and may require modest disassembly of surrounding components or access from underneath to reach the connector. The wiring harness generally travels toward the back of the engine toward the firewall.
Summary
The 2010 Honda Accord uses two common CKP sensor placements depending on engine choice: front-of-block near the timing cover for the 2.4L four-cylinder, and the side of the block near the transmission bell housing for the 3.5L V6. If you’re ever unsure, refer to the manual or a VIN-specific diagram to locate the exact sensor and connector, and exercise caution when working around the engine.