The engine air filter in a 2014 Jeep Patriot is housed in a rectangular plastic box in the engine bay, typically on the passenger side toward the front, connected to the intake hose.
The exact spot can vary slightly depending on your engine (2.0L World I4 or 2.4L Tigershark), but you’ll generally find the housing on the passenger side of the engine bay with a large intake tube feeding into it. Access is straightforward with basic tools, and the lid is usually secured with clips or a few screws.
Locating the air filter box
Follow these cues to identify the engine air filter housing and confirm its location before you begin any inspection or replacement.
- Open the hood and look toward the front passenger-side corner of the engine bay for a rectangular black plastic box with an intake hose connected to it.
- Trace the large-diameter intake hose from the grille area to the box; the hose typically enters the side or top of the housing.
- Note how the lid is secured—most Patriot housings use spring clips, though some may use small screws at the edges.
- Ensure the engine is cool before touching the housing to avoid burns or injury.
With the housing identified, you can proceed to open it and inspect or replace the filter as needed.
Replacing the air filter
If you need to replace the filter, follow these steps to ensure a proper fit and a good seal.
- Release the clips or remove the screws securing the lid of the air filter housing.
- Lift the lid to expose the filter element; observe the orientation of the old filter and any airflow arrow or markings on the new filter.
- Remove the old filter cartridge and check the inside of the housing for debris; wipe it clean if necessary.
- Insert the new filter with the correct orientation, making sure the rubber gasket sits evenly and the filter sits flush in the housing.
- Reposition the lid and reattach the clips or screws securely; reconnect any hoses that were detached during removal.
- Close the hood and run the engine briefly to ensure there are no air leaks around the housing.
Once the new filter is in place and the housing is sealed, the Patriot’s intake system should function properly and deliver clean air to the engine.
Summary
The 2014 Jeep Patriot’s engine air filter is typically located in a rectangular plastic housing on the passenger-side front area of the engine bay, connected to the intake tube. Access it by releasing the lid’s clips or screws, replace the filter with the correct orientation, and ensure the housing is securely sealed. If you can’t locate it, consult your owner’s manual or a service manual for your exact engine code (2.0L or 2.4L) to confirm the placement.
What are three symptoms of a clogged cabin air filter?
3 Signs Your Cabin Filter is Clogged
- There's Little Flow. The cabin filter is, essentially, a component of the air conditioner structure in your car.
- Dust. Another sign is is that you're seeing more than the usual amount of dust and debris inside your car.
- Less Vehicle Power.
How many air filters does a Jeep Patriot have?
There are two primary air filters in your 2012 Jeep Patriot.
Does a cabin air filter help with allergies?
Cabin air filters also help to reduce the amount of those allergens that can get into your vehicle. Pollen, dust and other allergens can build up in your filter during heavy pollen season, so you may need to change it sooner.
Where is the engine air filter in a Jeep Patriot?
Computer it's better not to touch. This. So you will not be touching. These screws around here you you'll be just lifting up the whole. Cover.