Answer in brief: The official jack points are one front-center point under the front subframe and two rear points at the pinch welds beside the rear wheels. Use a proper floor jack with pads and support the vehicle with stands on level ground.
Front jack point
Identify the dedicated front-center jack location on the Accord’s front subframe. This is a reinforced pad on the crossmember that sits between the front wheels and accepts a floor jack.
Locations and steps for the front-center jack point:
- Position the floor jack under the center of the front subframe crossmember, typically just behind the radiator support.
- Make sure the jack pad sits on the reinforced contact surface designed for lifting.
- Keep the vehicle on a flat, stable surface and chock the diagonally opposite wheel.
- Slowly raise the jack until the front wheel clears the ground, then place jack stands at the appropriate points before continuing.
- Avoid resting the jack on the engine oil pan, exhaust components, or suspension arms.
Conclusion: The front-center jacking point is a dedicated pad on the front subframe designed to safely lift the front of the Accord.
Rear jack points
For the rear, use the pinch weld points along the rocker panels near the rear wheels. These reinforced spots are intended for jacking from the sides.
Locations and steps for the rear pinch-weld jack points:
- Slide the floor jack under the pinch weld on either side, just behind the rear wheel.
- Align the jack pad with the reinforced area of the pinch weld and ensure solid contact.
- Raise smoothly to lift the rear of the car, then install rear jack stands at the designated rear support points.
- Avoid placing the jack under exhaust pipes, fuel lines, or body panels that aren’t reinforced for lifting.
Conclusion: The rear jacking points are on the rocker-panel pinch welds beside the rear wheels, providing stable support for lifting the back of the vehicle.
Safety and best practices
Always use a floor jack with a wide, padded contact surface, engage the parking brake, and chock the opposite wheels. Use jack stands on sturdy, designated points after lifting, and never rely on the jack alone to hold the vehicle.
Summary: For a 2018 Honda Accord, lift at the front-center subframe pad and the two rear pinch-weld points along the rocker panels. Verify exact locations in your owner’s manual for your trim, and consult a professional if you’re unsure.