The 2013 Chrysler 200 typically uses SAE 5W-20 motor oil, meeting Chrysler’s MS-6395 specification, for both the 2.4L Tigershark I-4 and the 3.6L Pentastar V6. Depending on engine choice and climate, the exact grade may vary, so checking the owner’s manual or with a dealer is advised.
Engine options and oil needs
Available engines in 2013
In 2013, the Chrysler 200 offered two engines. While the oil grade remains broadly consistent, always confirm the precise specification for your exact configuration and driving conditions.
Before listing the key oil specs, note the following:
- Viscosity: 5W-20 is the standard recommended grade for both engines in most markets.
- Certification: Use oil that meets Chrysler MS-6395 and API SN (or higher) service classifications.
- Oil type: Full synthetic or synthetic-blend 5W-20 is typically preferred; conventional 5W-20 may be acceptable only if specified in the manual.
- Reference: Confirm the exact requirement for your vehicle by consulting the owner’s manual or a dealer, as climate and driving conditions can influence the recommended grade.
Conclusion for this section: When in doubt, use 5W-20 oil that meets MS-6395, with synthetic or synthetic-blend formulations offering the best protection and performance for the 2013 Chrysler 200.
Maintenance notes and where to verify
Always verify the exact specification for your vehicle variant and climate in the owner’s manual. If you don’t have the manual handy, a Chrysler dealer or qualified mechanic can confirm the correct oil grade and certification for your 2013 200.
Summary
The 2013 Chrysler 200 is designed to run on 5W-20 motor oil that meets the Chrysler MS-6395 standard. This applies to both the 2.4L Tigershark and the 3.6L Pentastar engines, with synthetic or synthetic-blend formulations typically recommended. Always check the owner’s manual or consult a dealer to confirm the precise oil specification for your engine and local driving conditions, and follow the recommended change intervals for optimal engine health.