The most common front-wiper sizes for Mitsubishi Outlander models are 26 inches on the driver’s side and 19 inches on the passenger side, with an 11-inch rear blade. Exact sizes can vary by year and market, so it’s important to confirm for your specific vehicle.
Front wiper sizes by generation
The following breakdown highlights typical blade lengths by generation. Variations can occur based on trim level or regional specs.
- 2013–2021 (third generation): Front blades are 26 inches on the driver’s side and 19 inches on the passenger side; rear blade is typically 11 inches.
- 2022–present (fourth generation): Front blades remain 26 inches (driver) and 19 inches (passenger); rear blade is typically 11 inches.
Market-specific variants or optional equipment can alter blade lengths, so always verify against your specific model year and regional configuration.
How to verify your exact size
To ensure you buy the correct blades for your Outlander, follow these steps to confirm the exact sizes for your vehicle.
- Check the owner’s manual or the placard on the driver’s door jamb for the recommended blade lengths.
- Inspect the blades themselves; many blades have their size printed on the blade or connector.
- Measure the blade length if needed: fully extend the wiper and measure from tip to tip.
- When replacing, choose blades that match these measurements and opt for OEM or reputable aftermarket brands.
Using the correct sizes ensures optimal contact with the windshield and helps prevent streaking or poor performance during rain or snow.
Rear wiper considerations
The Outlander’s rear wiper is smaller than the front blades and is typically about 11 inches. Some markets or trims may use a different rear size, so confirm with your manual or a parts specialist if you’re unsure.
Summary
For most Mitsubishi Outlander models sold in recent years, plan for 26-inch driver-side front blades, 19-inch passenger-front blades, and an 11-inch rear blade. Always confirm your exact year, market, and trim before purchasing blades, then source replacements that match those measurements for optimal performance.