The front wiper blades on the 2010 Town & Country are typically 26 inches on the driver’s side and 18 inches on the passenger side, with a rear blade of about 11 inches.
For context, these sizes cover the two front blades that clear the large windshield and the smaller rear window on the tailgate. Official specifications can vary by trim or aftermarket replacements, so when in doubt verify with the owner's manual or measure the blades directly before purchasing replacements.
Front wiper blade sizes
Before listing the standard sizes used on most 2010 Town & Country models, note that front blade length is measured along the edge that sweeps the windshield. The most common configuration for this vehicle is as follows:
- Driver's side: 26 inches
- Passenger's side: 18 inches
The above sizes are the typical configuration for a 2010 Town & Country, though some aftermarket replacements or dealer-specific trims may differ. If your existing blades do not match, remove and measure or consult the manual.
Rear wiper blade size
Many Town & Country models in 2010 also include a rear window wiper with a smaller blade. The standard rear blade size is approximately 11 inches, but check your model's rear wiper arm and measure to confirm before buying a replacement.
- Rear: 11 inches
When replacing the rear blade, ensure you select the correct attachment type (hook or pin) and check the blade fit on your tailgate’s wiper arm.
How to replace wiper blades on a 2010 Town & Country
Before you start, gather blades of the correct length and type (conventional frame blade or beam blade). Steps:
- Turn off the ignition and gently lift the wiper arm away from the windshield until it stays in a raised position.
- Remove the old blade by pressing the release tab or small clip and sliding it off the arm.
- Attach the new blade by sliding it into place until you hear a click; ensure it is secure.
- Lower the arm back to the windshield and test the sweep with the wipers on a dry run, then in light mist if available.
Tip: If you are unsure about the attachment type, bring the old blade to the store or refer to the owner's manual to choose the correct connector style.
Summary
The 2010 Chrysler Town & Country typically uses 26-inch driver-side and 18-inch passenger-side front wiper blades, with an 11-inch rear blade. Always verify by measuring your current blades or consulting the owner’s manual, as aftermarket replacements or trims may vary. Replacing worn blades improves visibility and driving safety.