The lug nuts for a 2008 Honda Accord are M12 x 1.5 with a 60-degree conical seat, a 19 mm hex size, and they fit a 5 x 114.3 mm bolt pattern, torqued to about 80 ft-lb (108 Nm).
This article explains the exact lug nut specifications for the 2008 Accord, how to verify them on your wheels, and what to check if you’re using aftermarket hardware or locking nuts.
Standard lug nut specifications for the 2008 Accord
Below are the typical OEM specifications you’ll encounter on a 2008 Honda Accord with factory wheels.
- Thread size: M12 x 1.5
- Nut seat: 60-degree conical seat
- Hex size: 19 mm
- Bolt pattern: 5 x 114.3 mm
- Torque specification: 80 ft-lb (108 Nm)
These specifications apply to most trims equipped with standard wheels. If your vehicle wears aftermarket wheels or uses locking lug nuts, confirm compatibility with the wheel manufacturer and refer to the owner’s manual for any deviations.
Notes for aftermarket wheels and locking lug nuts
Some aftermarket wheels may require a different lug nut size or seat type. If your car has locking lug nuts, make sure you have the key, and verify that the replacement lugs match the seat and thread spec of the wheels to ensure a secure fit.
Summary
In short, the 2008 Honda Accord commonly uses M12 x 1.5 lug nuts with a 60-degree conical seat, a 19 mm hex, and a 5 x 114.3 mm bolt pattern, torqued to about 80 ft-lb (108 Nm). Always double-check the exact specs for your trim and wheels, especially if you’ve added aftermarket rims or locking nuts.