The 2017 Honda Pilot uses standard M12 x 1.5 lug nuts with a 60-degree conical (acorn) seat, tightened to about 80 ft-lbs (108 Nm). A 19 mm wrench is typically used to install or remove them. This applies to the stock wheels on that model year.
Specifications at a glance
These are the essential specs you’ll need when changing a tire or replacing wheel hardware on the 2017 Pilot.
- Thread size: M12 x 1.5 (12 mm diameter, 1.5 mm pitch)
- Seat type: 60-degree conical (acorn) seat
- Number of lug nuts per wheel: 5
- Wrench size: 19 mm across flats
- Torque specification: 80 ft-lbs (108 Nm)
For best results, always use the proper torque wrench and consult the owner's manual or dealer if you’re unsure about wheel compatibility.
When replacing wheels or using aftermarket parts, verify that the nut size, seat type, and thread pitch match the hub and wheel to avoid damage or improper seating.
Aftermarket wheels and compatibility
If you install aftermarket wheels, confirm that they are compatible with the vehicle’s lug nut system. Some wheels require a different seat type or pitch, and incorrect fasteners can lead to improper seating or safety risks. Always re-torque lug nuts after installation, typically following a short drive to seating, per service guidelines.
Additionally, after any wheel swap, recheck lug nut torque after 50–100 miles to ensure they remain at the specified tension.
Summary
In brief, the 2017 Honda Pilot uses M12 x 1.5 lug nuts with a 60-degree conical seat, five per wheel, tightened to about 80 ft-lbs, and tightened with a 19 mm wrench. Always verify torque with the owner's manual and use the correct hardware for OEM or aftermarket wheels, re-torque after installation, and follow maintenance practices to ensure wheel safety.