OEM lug nuts for the 2016 Honda Odyssey are M12 x 1.5 with a 60-degree conical (acorn) seat, and they use a 19 mm outer hex for the lug wrench. The factory torque is about 80 ft-lbs (108 Nm).
Understanding these specifications helps when rotating tires, replacing wheels, or installing aftermarket rims. The Odyssey uses a five-lug pattern, and matching the nut type, thread pitch, seating, and torque is essential for safe wheel mounting.
Lug nut specifications for the 2016 Honda Odyssey
Key specs that define the lug nuts used on this model are listed below. They cover thread size, seat type, hex size, and bolt pattern.
- Thread size and pitch: M12 x 1.5
- Seat type: 60-degree conical (acorn) seating
- Outer hex size (tool size): 19 mm
- Bolt pattern (wheel hub): 5 x 114.3 mm
Note: Aftermarket wheels may use different seat types or larger hex sizes. Always verify compatibility with your wheels and use the correct torque.
Torque specification and maintenance
To ensure safe fastening, use the factory torque specification and re-torque after a short drive as recommended by vehicle maintenance guidelines.
The typical lug nut torque for the 2016 Odyssey is around 80 ft-lbs (108 Nm). Use a calibrated torque wrench and follow the owner's manual guidance for re-checking after installation or wheel changes.
Summary
For a 2016 Honda Odyssey, lug nuts are M12 x 1.5 with a 60-degree conical seat and a 19 mm outer hex, on a 5x114.3 mm wheel pattern, tightened to about 80 ft-lbs. Always confirm with the OEM manual or dealer for your specific wheel configuration, especially if aftermarket wheels are installed.