The standard lug nuts for a 2016 Honda CR-V use a 19 mm (roughly 3/4 inch) hex socket, with wheel studs sized at M12 x 1.5 and a 60-degree conical seat. The vehicle’s wheels are mounted on a 5-lug pattern (5 x 114.3 mm) and are typically torqued to about 80 ft-lbs (108 Nm) during proper installation.
To understand this topic in depth, it helps to review the key hardware involved, how to identify the correct lug nuts for OEM versus aftermarket wheels, and best practices for installation and maintenance. The following sections break down the essential specifications and considerations you should know when inspecting, replacing, or re-torquing lug nuts on this model.
Key specifications you should know about the lug nuts and associated hardware are summarized below.
- Socket size (hex): 19 mm (3/4 in)
- Stud thread size: M12 x 1.5
- Seat type: 60-degree conical (tapered) seat
- Wheel stud diameter: 12 mm
- Lug pattern: 5-lug, 114.3 mm pitch
These specifications cover the typical factory configuration for a 2016 CR-V with OEM wheels. If you swap to aftermarket wheels, always verify the seat type, thread pitch, and any differences in the lug nut compatibility with the wheel and hub assembly.
Important considerations when replacing lug nuts or using aftermarket hardware include ensuring proper seat type and thread pitch, applying the correct torque, and using compatible lug nuts with the wheel studs and bore. Using the wrong size or seat can cause damage or unsafe mounting, and under- or over-tightening can lead to warping or stud failure.
- Always match lug nut type to the wheel’s seat (conical 60-degree for most Honda OEM wheels).
- Torque to specification (approximately 80 ft-lbs / 108 Nm) during reinstallation to ensure proper clamping without over-tightening.
- If wheels are aftermarket or have different hub bore or seat requirements, verify compatibility before installation.
In practice, sticking to OEM-recommended hardware and torque values helps maintain proper wheel retention and safety. If you're unsure about your specific vehicle trim or wheel package, consult the owner’s manual or contact a Honda service professional to confirm the exact lug nut size and torque for your setup.
Summary
For a 2016 Honda CR-V, expect lug nuts that require a 19 mm hex socket, with M12 x 1.5 thread and a 60-degree conical seat, mounted on a 5 x 114.3 mm lug pattern. Use a torque of about 80 ft-lbs (108 Nm) when reinstalling, and ensure compatibility with any aftermarket wheels by matching seat type and thread pitch.