The lug nuts are M12 x 1.5 with a 19 mm hex head, using a 60-degree conical seat, and there are four per wheel. Tighten to about 80 ft-lbs (108 Nm).
The 2011 Honda Fit (also known as the Jazz in some markets) uses standard wheel hardware designed for four-lug wheels. Knowing the correct lug nut size helps with wheel changes, maintenance, and safe reinstallation. This article provides the precise specs and practical notes for owners and technicians.
Key lug nut specifications
The Fit’s wheel fasteners follow a common sizing scheme used by many Honda compact cars. The thread size is M12 x 1.5, which refers to a 12-millimeter diameter with a 1.5-millimeter thread pitch. The lug nuts use a 60-degree conical (tapered) seating to match the wheel holes and studs, ensuring proper alignment and seating depth. The hex size across the flats is 19 millimeters, meaning a 19 mm socket or lug wrench is required to install or remove them. A standard set consists of four lug nuts per wheel, with no special locking arrangement unless your vehicle was fitted with aftermarket locking nuts or a factory option.
Thread size and seating
The M12 x 1.5 thread size is typical for the 2011 Fit and is compatible with OEM rims and many aftermarket wheels designed for this model. The 60-degree conical seat is the standard type for these wheel fasteners, ensuring proper bite and seating against the wheel hub.
Hex size and torque
A 19 mm wrench or socket is used to tighten or loosen the lug nuts. The recommended torque is approximately 80 ft-lbs (108 Nm). After installing wheels, it is common practice to recheck torque after a short drive (roughly 50–100 miles) to account for settling and thread seating.
Practical notes for owners
Most 2011 Fits come with four lug nuts per wheel. If your vehicle uses locking lug nuts, you’ll need the corresponding key to remove or install them. When replacing lug nuts, choose OEM or OEM-equivalent parts to ensure correct thread engagement and seating. Always use a calibrated torque wrench and adhere to the manufacturer’s torque specification to avoid under- or over-tightening.
Summary
In brief, the 2011 Honda Fit uses M12 x 1.5 lug nuts with a 19 mm hex head and a 60-degree conical seat, four per wheel, tightened to about 80 ft-lbs (108 Nm). If you have aftermarket wheels or special trims, verify compatibility with the original specifications and recheck torque after installation.