Front wipers for the 2010 Honda Accord typically use a 24-inch blade on the driver's side and a 19-inch blade on the passenger's side. Some trims or body styles may differ, so it's wise to verify against your specific vehicle.
Overview of front wiper sizing for the 2010 Accord
The 2010 Accord was offered in sedan and coupe formats. In most cases, the sedan uses a 24-inch driver-side blade paired with a 19-inch passenger-side blade, while variations can occur by body style or trim. Always check the size printed on the current blades or consult the owner's manual if you are unsure.
To help you verify and replace the blades correctly, use the following guideline:
- Check the owner's manual or the label on the current blade for size codes (look for 24-inch driver and 19-inch passenger).
- Remove the blades and measure their lengths if the labels are missing, using a tape measure from the blade’s center to its tip for each blade.
- Note the body style (sedan vs. coupe) and year; if in doubt, use 24 inches and 19 inches as baseline and confirm against the manual or current blades.
- Purchase blades labeled for 24 inches and 19 inches in lengths, and ensure compatibility with your wiper arm style (J-hook, pin, or bayonet).
- Install according to the blade’s instructions, aligning the attachment points with the hooks and locking mechanisms.
After installation, test the wipers at a safe speed to ensure full coverage without streaking. If you notice gaps or streaks, recheck blade length compatibility and attachment type.
Rear wiper note
Some 2010 Accord trims include a rear wiper. The rear blade is typically smaller, around 10–11 inches, but check your model’s specifics to confirm.
Summary
For the 2010 Honda Accord, the standard front wiper blades are typically 24 inches on the driver's side and 19 inches on the passenger's side. Always verify on your specific vehicle by checking the blade labels or the owner's manual, and replace blades with the correct sizes and attachment style. If your coupe or a particular trim differs, consult the manual or measure the current blades to be sure.