The 2015 Jeep Renegade uses two different oil filter designs depending on the engine: a traditional spin-on filter for the 2.4-liter Tigershark and a cartridge-style filter for the 1.4-liter MultiAir Turbo.
Engine options in the 2015 Renegade
In 2015, the Renegade was offered with two gasoline powertrains, and the filter design follows the engine type.
- 2.4L Tigershark I4 — spin-on oil filter that screws into the engine block.
- 1.4L MultiAir Turbo — cartridge-style oil filter located in a separate housing; replace only the cartridge element.
Knowing the engine helps determine the filter type, but the exact part number is VIN-specific and should be confirmed via the owner's manual or a Mopar parts catalog.
Finding the exact part number
To ensure you purchase the correct filter, use official sources and a VIN-based lookup.
- Check the vehicle’s owner’s manual or service section for the recommended filter and part numbers.
- Enter your VIN on the Mopar Parts website or contact a Jeep dealer to pull the exact part number for your engine.
- If you prefer aftermarket, choose a reputable brand that lists compatibility for the 2.4L Tigershark or the 1.4L MultiAir Turbo Renegade engines.
Even with cross-references, always confirm the filter matches your specific engine type and thread size before purchase.
Installation tips and maintenance best practices
Follow these practical steps to install or replace the oil filter safely and effectively.
- Use a replacement oil filter that suits your engine type; for spin-on filters, replace the gasket as well.
- Lubricate the new filter seal with a dab of clean engine oil before installation.
- After installation, run the engine briefly, check for leaks, and recheck the oil level, topping up if needed.
- Dispose of used oil and the old filter according to local regulations.
Adhering to the recommended maintenance schedule helps protect the engine and maintain performance.
Summary
In short, the 2015 Jeep Renegade’s oil filter design depends on the engine. The 2.4L Tigershark uses a spin-on filter, while the 1.4L MultiAir Turbo uses a cartridge-style filter. Always verify the exact part number with the owner's manual or a VIN-specific Mopar parts catalog, and choose a trusted OEM or reputable aftermarket filter. This approach ensures proper oil flow and engine longevity.
Where is the oil filter on a 2015 Jeep Renegade?
Plug. Once your oil's finished draining. Go ahead and slide your oil pan to the front by the oil filter and remove the oil filter. If your oil filter is too tight use a filter wrench.
What type of oil do I need for a 2015 Jeep Renegade?
Jeep Renegade Oil Type Recommended by the Manufacturer
If you own a Jeep Renegade with a 1.4L engine, the manufacturer recommends SAE 5W-40 full synthetic oil. For the larger, 2.4L engine, use SAE 0W-20 full synthetic oil.
Can a Jeep Renegade drive in the snow?
High Ground Clearance: Jeeps are built to handle uneven terrain, making them perfect for deep snow. Durable Design: From skid plates to reinforced frames, Jeeps are built to withstand tough conditions.
What oil filter does a Jeep Renegade use?
MO-090) Genuine MOPAR Original Equipment Oil Filter for your vehicle.