The 2011 Honda Fit’s 1.5-liter engine typically uses Honda’s standard spin-on oil filter, with the most commonly cited OEM part number being 15410-RAA-003. Regional variations can exist, so it’s best to confirm the exact part number for your car using your VIN or by checking with a Honda dealer or parts catalog.
Identify the correct filter for your Fit
To avoid buying the wrong part, use official catalogs and cross-reference your vehicle identification number. The following notes outline the typical numbers and how to verify them.
OEM part number
The filter used on most 2011 Fits is the Honda oil filter with part number 15410-RAA-003. Depending on production region, you may encounter a sibling variant such as 15410-RCA-003; verify with a dealer or parts catalog.
- 15410-RAA-003 — commonly listed for 2011 Fit 1.5L in many markets.
- 15410-RCA-003 — regional variant found on some builds; confirm with dealer or parts catalog.
Always confirm the exact PN with your dealer or by checking the parts catalog for your specific VIN, as substitutions can exist by market or production date.
How to replace and maintain the filter
If you plan to perform the oil change yourself, follow these general instructions to replace the filter and refresh the engine oil while ensuring proper fit.
- Prepare tools and materials: a new oil filter, the appropriate engine oil, a drain pan, a wrench or filter-removal tool, protective gloves, and clean rags.
- Warm up the engine briefly, then turn it off and secure the vehicle. Place the drain pan beneath the oil pan.
- Drain the used oil by removing the drain plug and allow it to fully drain.
- Remove the old oil filter using a filter wrench, taking care not to spill hot oil.
- Lubricate the rubber gasket of the new filter with a small amount of fresh oil, then thread it on by hand until snug; avoid over-tightening.
- Refill with the recommended oil type and quantity for the 2011 Fit, then start the engine and check for leaks.
- Shut off the engine, recheck the oil level with the dipstick, and top up if necessary.
If you’re unsure about the process or the exact oil specification for your region, consider having the service performed by a professional technician or at a dealer service department.
Summary
For the 2011 Honda Fit, the typical OEM oil filter is 15410-RAA-003 for the 1.5L engine, with regional variants possible. Always verify the exact part number using your VIN and consult your owner's manual or dealer for precise guidance. When replacing, pair the correct filter with the proper oil grade and follow standard oil-change steps to ensure a proper seal and leak-free operation.