What oil filter does a 2009 Honda Civic LX take?

The 2009 Honda Civic LX (1.8L) uses Honda’s standard oil filter, with the official part number 15208-RAA-A01. You can also choose compatible aftermarket filters that specify fitment for the 2006–2011 Civic 1.8L.

The exact filter you need

For the 2009 Civic LX, the Honda OEM oil filter is 15208-RAA-A01. This filter is designed for the 1.8-liter engine used in Civics from 2006 through 2011. Some earlier revisions may have different numbers, so verify the part number on your vehicle’s parts diagram or consult your owner's manual if you’re unsure.

Honda part number

The standard factory-recommended filter for this car is 15208-RAA-A01. When shopping, look for this exact code to ensure proper fitment and filtration performance.

Aftermarket compatibility

Many reputable aftermarket filters are designed to fit the 2006–2011 Civic 1.8L. If you choose an aftermarket option, confirm that the product page specifically lists compatibility with 2006–2011 Honda Civic 1.8L to ensure a proper seal and filtration efficiency.

Oil type and capacity

In addition to the right filter, using the correct oil is essential for protection and performance. The standard recommendation for the US market is 5W-20 engine oil. The total oil capacity with a new filter is about 4.4 quarts (roughly 4.2 liters).

Recommended oil

5W-20 is the typical specification recommended by Honda for this engine. Some climates or markets may allow other viscosities, but consult the owner’s manual or a local dealer for guidance specific to your region.

How to replace the oil filter

Below are the steps you’d typically follow to change the oil filter on a 2009 Civic LX. This process also covers the oil change, since both tasks are usually done together.

• Gather supplies: new oil (5W-20), new oil filter (15208-RAA-A01 or equivalent), drain pan, socket/wrench set, funnel, and jack stands or ramps.


• Warm the engine briefly to loosen the old oil, then park on a level surface and engage the parking brake.


• Lift the front of the car and secure it with stands if needed. Place the drain pan beneath the oil pan.


• Remove the drain plug and allow the old oil to drain completely.


• Remove the old oil filter; be prepared for residual oil to spill.


• Prep the new filter by lightly coating the gasket with fresh oil, then install it by hand until snug and finish with a quarter to half turn per the filter’s instructions.


• Reinstall the drain plug once the oil has finished draining.


• Pour in the new oil through the oil filler cap using a funnel, starting with about 4.0 quarts and checking the level.


• Start the engine, run for a minute, then turn off and check for leaks. Allow the oil to settle and recheck the dipstick, adding more oil if necessary to reach the full mark.

Regularly changing the oil and the filter on schedule helps protect the engine from wear and debris. Always dispose of used oil and filters responsibly at an appropriate recycling facility.

Summary

For a 2009 Honda Civic LX with the 1.8L engine, use Honda’s oil filter part number 15208-RAA-A01, or a compatible aftermarket filter listed for 2006–2011 Civic 1.8L models. Pair it with 5W-20 oil and about 4.4 quarts of total capacity (with filter). This combination supports proper filtration, lubrication, and engine longevity when changed at the recommended intervals.

What oil filter do I need for a 2009 Honda Fit?

15400-PLM-A02) Genuine Honda original equipment oil filter for your Honda vehicle. Engineered and specified by Honda, this is the same filter as that which would be installed by your dealer.

What oil filter does a Honda Civic take?

Honda OEM Oil Filter | Honda Civic (all non Type R) 2016-2021 (15400-PLM-A02) Honda Genuine OEM Oil Filter for all Honda Civic models 2016 and up except for Type R.

What kind of oil does a 2009 Honda Civic LX take?

Oil Grade: API*

What size oil filter does a 2009 Honda Civic take?

8L L4 Gas Oil Filter.