The 2020 Renegade with the 2.4L Tigershark engine uses synthetic motor oil with a viscosity of 0W-20 as the standard grade, and the engine holds about 5 quarts (roughly 4.7 liters) of oil with a filter. Always confirm the exact specification for your vehicle in the owner's manual or on the under-hood label for your market.
Oil specification for the 2.4L Tigershark
The 2.4L Tigershark engine in the 2020 Renegade is designed to run on high-quality synthetic motor oil. The recommended viscosity is 0W-20 in most markets, with a preference for a synthetic formulation that meets API SN or newer and ILSAC GF-5 or GF-6 requirements. In some regions, dealers may indicate 5W-20 as an acceptable alternative if 0W-20 is unavailable, but 0W-20 is generally preferred for optimal cold-start performance and fuel economy.
Recommended oil grade options
Below is a concise guide to the typical oil grade choices you’ll encounter for this engine. A single, definitive grade is specified by the manual for standard conditions, with allowances for regional availability.
- 0W-20 synthetic oil (preferred standard grade for most markets)
- 5W-20 synthetic oil (acceptable alternative in some regions if 0W-20 isn’t available, but not the first choice)
The list above captures the primary options. Always opt for a high-quality synthetic oil that meets the vehicle’s API and ILSAC standards and follow the regional guidance from your dealer or manual.
Oil capacity and filter
Knowing the capacity helps ensure you perform an accurate oil change and use the correct amount of oil. The 2.4L engine in the 2020 Renegade holds about 5 quarts (approximately 4.7 liters) of oil when performing a full change, including the filter. Use a new oil filter compatible with the 2.4L Tigershark with every oil change.
- Oil capacity: about 5.0 quarts (4.7 liters) with filter
- Oil filter: standard replacement filter for the 2.4L Tigershark; use a new one at every change
- Recommended change interval: follow the factory schedule for synthetic oil, typically around every 7,500 miles (12,000 km) or as indicated by the vehicle’s oil life monitoring system
Note that exact capacity can vary slightly by model year, trim, and climate. Always verify with the owner’s manual or your dealer for the precise figure.
Practical notes on choosing oil and maintenance
For warranty compliance and optimal engine protection, use a Mopar-approved or equivalent high-quality synthetic oil that meets the stated API and ILSAC standards. Observe the maintenance schedule and rely on the vehicle’s oil life monitoring system to guide changes. In extreme temperatures, 0W-20 is typically favored for better cold-start performance, while some regions may operate effectively on 5W-20 if advised by a dealer.
Summary
The 2020 Jeep Renegade 2.4L typically requires synthetic 0W-20 motor oil, with an oil capacity of about 5 quarts including the filter. 0W-20 is the standard recommendation, though 5W-20 may be listed as an alternative in some regions. Always consult the owner’s manual or a dealer for the exact specification for your vehicle and use a reputable synthetic oil that meets API SN or newer and ILSAC GF-5 or GF-6 requirements. Following the recommended oil type and change intervals helps maintain engine performance and warranty coverage.