The majority of 2010 Dodge models use 5W-20 motor oil, with 5W-30 required for some engines or climates. Always verify the exact grade from your owner's manual or the under-hood sticker to avoid using the wrong oil.
Understanding the oil requirements for 2010 Dodge models
The 2010 Dodge lineup covered a range of engines—from efficient four-cylinders to high-performance V8s—each with its own oil specification. While 5W-20 is the default viscosity for many modern Dodge engines, certain powerplants or operating temperatures may call for 5W-30. Using the correct viscosity and specification helps maintain lubrication, fuel efficiency, and overall engine longevity.
How to verify the exact oil for your car
To determine the precise oil grade for your 2010 Dodge, use these checks:
- Consult the owner's manual for the exact viscosity and specification for your engine.
- Inspect the oil fill cap under the hood for the printed grade (for example, 5W-20 or 5W-30).
- Look at the driver’s side door jamb sticker or under-hood label for the recommended oil type.
- If still unsure, use your vehicle’s VIN lookup or ask a dealer/service professional for confirmation.
By following these steps, you ensure you are using the correct oil for your engine and driving conditions.
Common guidance for oil grades in 2010 Dodge engines
This general guide covers typical cases, but the exact grade should be confirmed for your specific model and engine family.
- 5W-20 is the most common viscosity for many 2010 Dodge engines, especially in normal climates.
- 5W-30 is used for certain engines or hotter climates, as specified by the manual.
- Use oil that meets Mopar MS-6395 (the Chrysler specification) or the current API/SN-equivalent standard as applicable to your engine.
Following the recommended grade and specification helps ensure proper lubrication, performance, and emissions compliance across the model range.
Maintenance notes and oil-change intervals
Oil-change intervals vary with oil type and driving conditions. Conventional oil commonly falls in the 3,000–5,000 mile range, while synthetic blends or full synthetic can extend to about 5,000–7,500 miles. Always follow the factory-recommended interval in your manual and refer to the windshield sticker or service records if you’re unsure.
Summary
For a 2010 Dodge, the typical recommendation is 5W-20, with 5W-30 as an alternative in certain engines or climates. Always verify the exact grade and specification for your vehicle using the owner's manual, fill-cap imprint, and door jamb sticker, and use oil that meets Mopar MS-6395 or the current API specifications. When in doubt, consult a Dodge dealer or qualified technician with your VIN.
What kind of oil does a 2010 Dodge Ram 4.7 take?
AMSOIL OE 5W-20 100% Synthetic Motor Oil.
What kind of oil for a 2010 Dodge?
Synthetic blend 5w-20 engine oil that provides durable wear protection and reduces engine wear.
Can I use 5W-30 instead of 5W20 in my Dodge?
Using 5W-30 instead can reduce fuel economy and impede flow throughout the engine. While using it temporarily in a pinch likely won't cause your engine lasting harm, remember that the engineers who built your engine did so with a specific viscosity oil in mind, meaning it's best to stick with it.
What kind of oil does a 2010 Dodge take?
Takes six quarts of 10W30.