The 2014 Honda CR-V requires SAE 0W-20 engine oil as the standard lubricant. If 0W-20 is not available, SAE 5W-20 is an acceptable alternative. Both grades should meet API SN or newer and ILSAC GF-5 or newer specifications. Always confirm the exact requirement on the owner's manual or the oil filler cap.
Oil type and specifications
Key specifications for the CR-V’s engine oil are summarized in the list below, including the recommended viscosity, acceptable alternative, and the certification standards.
- Viscosity: 0W-20 (recommended)
- Alternative: 5W-20 if 0W-20 is not available
- Oil type: Full synthetic or synthetic-blend oil that meets API SN (or newer) and ILSAC GF-5 (or newer)
Note: Always verify with the owner's manual or the oil cap, as specifications can vary by market or trim level.
Choosing synthetic vs conventional oil
Honda generally approves both full synthetic and conventional (0W-20) oils as long as they meet the required API and ILSAC standards. Synthetic oils typically offer longer drain intervals and better high-temperature protection, though any oil used should strictly conform to the stated specifications.
Oil capacity
The following figures pertain to a standard oil change on the 2014 CR-V’s 2.4L engine (with filter change included).
- Oil capacity (with filter): approximately 4.5 quarts (4.3 liters)
After draining the old oil and installing a new filter, fill to the full mark and recheck with the dipstick to ensure proper oil level.
Summary
For a 2014 Honda CR-V, use SAE 0W-20 engine oil as the default, with 5W-20 as a backup if 0W-20 isn’t available. Use oil that meets API SN or newer and ILSAC GF-5 or newer, and choose either full synthetic or synthetic-blend as permitted. The engine oil capacity is about 4.5 quarts with a filter. Always refer to the owner's manual or under-hood labeling for the exact specification and follow the maintenance minder guidance for oil changes.