For the 2002 Honda CR-V, the oil filter is a standard spin-on type used with the 2.4-liter engine, with Honda Genuine part number 15410-PRB-003 being the common reference. Aftermarket filters that match the same thread size and specifications will also fit. Always verify fitment for your exact vehicle variant using your VIN or a trusted parts catalog.
Engine context and filter type
The 2002 CR-V sold in most markets runs the 2.4-liter K24A1 engine. This engine uses a spin-on oil filter (not a cartridge-type filter) with a standard 3/4-16 thread and an anti-drainback valve to help lubrication on startup. Oil capacity with a filter change for the 2.4L is typically around 5.2 quarts, and the oil grade is specified by Honda for your climate and driving conditions.
Part numbers and compatibility
For the US market, the Honda Genuine oil filter most often used with the 2.4L K24A1 is 15410-PRB-003. Other markets or slightly different configurations may use a closely related number in the 15410-PRB family. When in doubt, confirm the exact part number with a dealer or by checking the vehicle’s VIN in a parts catalog. Aftermarket filters that match the 3/4-16 thread and meet Honda’s performance standards are widely available.
How to source the right filter
To ensure you buy the correct filter for a 2002 CR-V, follow these checks:
- Identify your engine code (K24A1 for most 2002 US CR‑V models) and confirm the vehicle uses a spin-on filter.
- Confirm the thread size is 3/4-16 and the gasket diameter matches the mounting surface.
- Use your VIN to pull the exact Honda part number or an approved aftermarket equivalent from a parts retailer.
In practice, most drivers use Honda Genuine or a reputable aftermarket filter that explicitly lists compatibility with the 2.4L Honda K-series engine family and a 3/4-16 thread.
Installation tips and maintenance
Replacing the oil filter on a 2002 CR-V is straightforward, but proper technique helps prevent leaks and engine wear:
- Lightly oil the gasket on the new filter before installation to ensure a proper seal and easy removal later.
- Torque the filter to the manufacturer’s specification (often around 18–23 ft-lbs for Honda spin‑ons; check your service manual for the exact figure).
- Dispose of the used filter and oil responsibly; recycle through an appropriate facility or service center.
Always verify the torque specification and gasket seating for your specific VIN and engine configuration.
Summary
The 2002 Honda CR-V uses a spin-on oil filter for its 2.4L engine, with Honda Genuine 15410-PRB-003 as the typical reference. Aftermarket filters that match the 3/4-16 thread and meet Honda’s standards will fit. Confirm exact part numbers and compatibility with your VIN or dealer resources to avoid mistakes.