The 2017 GMC Yukon with a 5.3-liter V8 engine generally requires about 8 quarts of engine oil when performing a full oil change with a new filter.
Understanding the oil capacity for this Yukon model
Oil capacity is the total amount of oil the engine can hold after a complete drain. For a 2017 Yukon equipped with the 5.3 L V8, GM's official specification lists a fill of around 8 quarts when you replace the oil filter. Actual amounts can vary slightly due to manufacturing tolerances and whether you replace the filter, so the best practice is to prepare for about 8 quarts and verify the level on the dipstick after filling.
Official capacity for the 5.3 L Yukon
Below is the standard figure used by GM service manuals and dealership literature.
- 8 quarts (with new oil filter installed)
For routine oil changes on the 2017 Yukon with the 5.3 L engine, plan to have roughly 8 quarts of oil on hand and fill to the full mark after installing a new filter.
Choosing oil and following the fill procedure
Use the recommended viscosity and the Dexos1 Gen 2 specification to ensure compatibility and warranty compliance. The most common choice for this engine is 5W-30 in most climates, with full-synthetic or synthetic-blend options available. Always verify the exact specification in your owner's manual or with a GM dealer for your VIN, as some engines or markets may have different recommendations.
- Recommended oil: Dexos1 Gen 2 5W-30 (or the grade specified in your owner's manual)
- Oil capacity during an oil change with a new filter: about 8 quarts
- Note: Always replace the oil filter during an oil change to maintain proper capacity and filtering efficiency
After completing the change, start the engine, run for a few minutes, then recheck the dipstick and add more oil if the level is below the full mark.
How to verify oil level safely
Follow these steps to confirm the correct oil level after a change:
- Park on level ground and wait several minutes after engine shutoff (to let oil settle).
- With the engine off, pull dipstick, wipe clean, reinsert, then pull again to read level.
- The oil should be at the full mark on the dipstick when cold or at the manufacturer-recommended operating level when warm.
Avoid overfilling, which can cause foaming and engine damage; if you do overfill, drain excess oil to reach the full line again.
Summary
For a 2017 GMC Yukon with a 5.3 L V8, plan for about 8 quarts of engine oil for a complete oil change with a new filter. Use a Dexos1 Gen 2 5W-30 grade and follow standard oil-change procedures to ensure proper fill and filter replacement. Always consult your vehicle’s manual for VIN-specific guidance.