The 2019 Mitsubishi Mirage generally uses a cartridge-style oil filter mounted in a dedicated housing rather than a traditional spin-on canister. This means you replace only the internal filter element and the housing’s O-ring at each oil change.
In this article, we explain the filter type, how to identify it, and provide practical steps for replacement, plus tips on choosing the right filter and maintenance reminders.
Oil filter type for the Mirage
For most 2019 Mirage models (1.2L three-cylinder), the oil filter is a cartridge-type element housed inside a filter housing. The cartridge is removed and replaced during an oil change, and a new O-ring or gasket is installed on the housing to ensure a proper seal. This design is common in many modern subcompact engines and helps with filter disposal and maintenance.
If you’re unsure which design your specific vehicle uses, inspect the area around the oil filter housing: a removable cap over a cartridge indicates a cartridge-style system rather than a visible spin-on canister.
Always consult your owner's manual for the exact filter type, part numbers, and torque specifications for the housing cap, as these can vary by market and production date.
How to replace the oil filter
To ensure you follow the correct sequence and use compatible parts, review these replacement steps before you begin.
Follow these steps to replace the cartridge oil filter in a 2019 Mirage:
- Warm up the engine, then park on a level surface and turn off the ignition. Jack up the car if needed and place a drain pan under the oil pan.
- Remove the engine oil filler cap to relieve pressure and help with draining.
- Safely drain the engine oil by removing the drain plug and letting the oil flow into the pan.
- Locate the oil filter housing and remove the housing cap using the appropriate tool or wrench.
- Take out the old cartridge filter from the housing and discard it. Clean any debris from inside the housing.
- Install a new cartridge filter into the housing and replace the housing O-ring/gasket with a new one. Reinstall the housing cap and tighten to the manufacturer’s torque specification.
- Refill the engine with the recommended oil amount and grade, then start the engine and check for leaks. Recycle the used oil and filter properly.
Concluding note: Adhering to correct steps and using the right cartridge filter and new O-ring helps prevent leaks and ensures proper lubrication.
Choosing the right filter and parts
Selecting the correct cartridge filter and related parts is essential for reliable service on a 2019 Mirage. Here are typical options and what to look for:
- Mitsubishi Genuine Oil Filter Cartridge specific to the Mirage 1.2L engine
- Reputable aftermarket cartridge filters that fit the Mirage 1.2L (ensure compatibility with your VIN and market)
- New housing O-ring or gasket, and an optional housing sealant if recommended by the filter manufacturer
Concluding note: Always verify compatibility for your market and engine variant, and replace both the cartridge filter and the housing O-ring to ensure a proper seal and optimal oil flow.
Summary
In short, the 2019 Mitsubishi Mirage uses a cartridge-style oil filter housed in a dedicated housing rather than a traditional spin-on filter. When changing the oil, replace the cartridge element and the housing’s O-ring, follow the steps above, and use the correct filter and oil grade specified for your region. This approach helps maintain engine lubrication and longevity.