The 2010 Honda Insight uses 5W-20 full-synthetic engine oil.
In practice, Honda’s guidelines for this model specify a light viscosity (5W-20) with synthetic oil preferred for best protection and fuel efficiency. The oil should meet API SN or newer and ILSAC GF-5 or newer, and you’ll typically need about 3.7 quarts (3.5 liters) of oil with a filter change. Always confirm the exact requirements in the owner's manual or with a Honda service advisor, especially if you’re living in extreme temperatures.
Oil specifications
The following details help ensure you choose the correct oil for the 2010 Insight.
Viscosity and oil type
Use a 5W-20 grade and prefer full-synthetic oil for optimal performance in this hybrid powertrain. If only a synthetic blend is available, it can be acceptable in a pinch, but full synthetic is recommended.
- Viscosity: 5W-20
- Oil type: Full synthetic recommended (synthetic blend acceptable if necessary)
- Certifications: API SN or newer; ILSAC GF-5 or newer
- Compatibility: Honda-approved oil meeting the above specs
Using the specified oil supports engine reliability, fuel economy, and proper operation of the hybrid system.
Capacity and maintenance
Oil capacity for a standard drain and filter change is approximately 3.7 quarts (3.5 liters).
- Capacity: About 3.7 quarts (3.5 L) with a new filter
- Maintenance: Follow the owner's manual or maintenance minder for intervals; synthetic oil may allow longer intervals
Always verify the exact specifications in your manual, as regional requirements can vary slightly.
Summary: For a 2010 Honda Insight, use 5W-20 full-synthetic engine oil, meeting API SN or newer and ILSAC GF-5 or newer. Plan to replace about 3.7 quarts of oil with the filter, following the maintenance schedule in the owner’s manual.
What oil does a 2010 Honda Insight use?
Oil Grade: API*
| Viscosity: | 0W-20 (All TEMPS) |
|---|---|
| Capacity: | 3.2 quarts. w/of. After refill check oil level. |
| Capacity: | 3.4 quarts (with filter). After refill check oil level. |
| Torque: | 29 ft/lbs (Oil Drain Plug) Install a new washer on the drain bolt. Only use an OE drain plug. |
What type of oil does a 2010 Honda use?
The 2010 Honda Civic commonly uses 5W-20 or the oil grade specified in the owner's manual.
What type of oil do I need for my Honda Insight?
Mobil 1 – High Mileage 0W-20 Full Synthetic Motor Oil, Extends Engine Life, 5 Quart (Part No.
Can I put 5W-30 oil in a Honda?
Systems honda is very specific about oil viscosity requirements most modern Honda engines call for 0W20. Oil some older models use 5W30. These aren't suggestions their engineered requirements.