The brake caliper bracket mounting bolts on the 2011 Honda Accord front axle are typically torqued to 65 N·m (48 ft-lb).
Context and what the specification covers
The torque value refers to the two bolts that secure the brake caliper mounting bracket to the steering knuckle on the front suspension. Correctly torquing these bolts is essential to keep the caliper aligned, prevent rotor wear, and ensure consistent braking performance. This figure applies to the front axle; rear brake configurations use different torque values.
Official specification for the 2011 Accord
The following figure reflects the commonly cited factory specification for the front caliper bracket mounting bolts on a 2011 Honda Accord. VIN, trim, or brake system variations can affect the exact value, so always confirm with the factory service data for your vehicle.
Before presenting the specification, ensure you know which assembly you are servicing: front caliper bracket to knuckle bolts, not the caliper-to-bracket guide bolts.
- Front brake caliper bracket bolts (bracket to knuckle): 65 N·m (48 ft-lb).
Before applying the list, this paragraph explains what you are about to see: the primary torque specification for the front brake caliper bracket mounting bolts on the 2011 Accord.
Note: This value is specific to the front axle bracket-to-knuckle bolts. Rear axle caliper brackets use different torque specifications and should be looked up separately for your exact vehicle configuration.
Notes on applying torque
Use a calibrated torque wrench, clean threads, and tighten to the specified torque. Apply thread lubricant only if the service data requires it. After initial tightening, inspect caliper alignment and rotor clearance before returning the vehicle to service. If bedding-in or re-check procedures are specified in your manual, follow those guidelines.
Other related brake fasteners and their torques
The brake system includes several fasteners that require accurate torquing. The following guidelines cover typical values for related components, but you must verify exact numbers for your specific vehicle and brake setup in the Honda service data or approved repair databases.
Before presenting the list, this paragraph explains why these related torques matter and how they relate to the caliper bracket process.
- Caliper mounting bolts (to the caliper): 20–25 N·m (15–18 ft-lb).
- Guide pin bolts (caliper guide pins): 10–14 N·m (9–12 ft-lb).
Aftercare note: this section covers other brake fasteners that commonly appear during a caliper/bracket service.
Conclude by rechecking all fasteners after a brief road test and consult the manual for any model-year bulletins or revisions that affect these values.
How to torque correctly
Steps for proper torque application include cleaning bolt holes, inspecting threads for damage, applying any required lubricant per the service data, and using a properly calibrated torque wrench. After installation, verify caliper alignment and perform a cautious brake test in a controlled environment before returning to normal driving.
Summary
For a 2011 Honda Accord, the front brake caliper bracket mounting bolts are commonly torqued to 65 N·m (48 ft-lb). This specification applies to the bracket-to-knuckle bolts on the front axle; always verify exact values for your VIN and brake configuration in the factory service data. When in doubt, consult the official Honda service manual or a trusted repair database to ensure accuracy.