The oil drain plug for a 2013 Honda Fit typically uses a 14 mm thread with a 1.5 pitch (M14 x 1.5) and has a hex drive that requires a 17 mm tool to turn. In practice, a 17 mm socket or wrench is used to remove and reinstall the plug, usually with a new crush washer for a proper seal.
This article explains the sizing, how to identify the plug, and what you should have on hand when performing an oil change on this model.
Sizing and compatibility
The critical measurements for the 2013 Honda Fit’s oil drain plug are the thread size and the tool you need to remove it. The standard configuration is M14 x 1.5 with a 17 mm drive. A new washer is typically used when reinstalling the plug to ensure a proper seal. The following details summarize these measurements and related considerations.
Before listing the specifics, here are the essential sizing details and tool requirements:
- Thread size: M14 x 1.5 (14 mm diameter with a 1.5 mm pitch)
- Drain plug head/drive: 17 mm socket or wrench
- Replacement seal: copper or soft-metal crush washer is normally used with a new plug
- Note on variations: some markets or aftermarket parts may differ; verify with the service data for your VIN
Using the correct plug and washer helps ensure a proper seal and prevents leaks after an oil change.
Verifying the plug on your vehicle
If you need to confirm, inspect the current drain plug. Measure the threads and compare the head size with a standard 17 mm tool. When in doubt, consult the owner's manual or a Honda dealer for VIN-specific data.
Additional notes and where to find official data
For owners, shop manuals, and service data, the most reliable sources are Honda's official service information, the owner's manual, or certified technicians. While the M14 x 1.5 with a 17 mm drive is typical, variations can occur by market or engine option.
Summary
In short, the oil drain plug on a 2013 Honda Fit is generally M14 x 1.5 with a 17 mm drive, requiring a 17 mm tool and a new crush washer for a proper seal. Always verify against your VIN and use the correct washer when performing an oil change.
What size socket for Honda drain plug?
What size socket do I need for my car's oil drain plug? Most cars use oil drain plugs between 13mm and 17mm, depending on the brand. For example, Toyota and Honda typically use 14mm or 17mm, while Ford often uses 13mm or 15mm.
What size is the oil drain plug washer on a Honda Fit?
14mm
Oil Drain Plug Washer 14mm. Recommended to be replaced each oil change.
What size socket do I need to remove a drain plug?
What size wrench do I need for my oil drain plug? The most common sizes are 14 mm, 15 mm, and 17 mm hex. Some vehicles use a 3/8-inch square drive or an internal Allen key (8 mm or larger). Check your owner's manual or measure the plug directly.
What size is the drain plug on a 2013 Honda Fit?
17 mm
Dorman – Standard Engine Oil Drain Plug: M14-1.50 Thread, 17 mm Head, 1 Bag (Part No. 090-033.1)