The commonly cited oil filter part number for a 2000 Honda Prelude with the H22A engine is Honda Genuine Part No. 15410-PT3-004. Always verify with your vehicle’s VIN and engine code to ensure exact compatibility.
The 2000 Prelude sits in the late-1990s to early-2000s era of Honda’s VTEC-era lineup. Because Honda sold the Prelude in different markets and with slightly different submodels, part numbers can vary by region and specific engine configuration. This article explains the official number most often associated with that year and how to confirm it for your car.
OEM part number for the 2000 Prelude
Below is the OEM oil filter part number most commonly associated with the 2000 Prelude’s engine configuration in typical US-market documentation.
- Honda Genuine Part No. 15410-PT3-004
Using the Honda part number above will help ensure you get the correct filter for the H22A-powered Prelude. If you’re shopping from a regional parts catalog, always cross-check the listed number against your VIN and engine code to avoid a mismatch.
How to verify the correct filter for your car
Use these steps to confirm you’re ordering the right oil filter for your vehicle, especially if your car isn’t in the exact same regional spec as the original example.
- Check your VIN and engine code. US Prelude models around 2000 with the H22A1 engine typically align with 15410-PT3-004, but regional variations exist.
- Inspect the existing filter or its packaging for the part number. If it matches 15410-PT3-004, you’re likely correct.
- Consult the dealer or HondaParts catalogs online by entering your VIN to pull the exact OEM part number for your specific car.
- If you plan to use an aftermarket filter, verify compatibility by matching thread size, gasket diameter, and overall length to the OEM spec.
Following these steps helps ensure you don’t end up with a filter that doesn’t seal properly or threads that don’t match.
Additional considerations and context
While 15410-PT3-004 is the number most often cited for the 2000 Prelude, variations can occur in non-US markets or with certain submodels. When in doubt, verify with a parts professional using your VIN, or physically compare the old filter to a replacement before installation.
Where to buy and how to install
Official Honda parts websites, authorized dealers, and reputable auto parts retailers commonly list 15410-PT3-004 as the correct OEM filter for this vehicle. When purchasing, consider saving the filter’s packaging details and refer to the installation instructions to replace the filter properly.
To install, follow standard oil-change procedures: drain the old oil, remove the old filter, install the new filter by hand to snug plus a quarter-turn (as specified by the filter’s instructions), and refill with the correct type and amount of oil for your engine.
Summary
For a 2000 Honda Prelude with the H22A engine, the OEM oil filter most commonly used is Honda Genuine Part No. 15410-PT3-004. Always verify compatibility with your VIN and engine code, and consult a dealer or parts catalog if you’re in a different region or dealing with a variant of the Prelude. Proper verification helps ensure a proper seal, correct thread engagement, and reliable engine lubrication.