The bolt pattern for the 2019 Audi Q7 is 5x112, with a 66.6 mm center bore.
This means the wheel has five lug holes arranged around a 112 mm circle, and the hole in the wheel that fits over the hub is 66.6 mm in diameter. This pattern is common across many Audi and VW Group vehicles from that era, which helps with cross-compatibility of wheels and accessories while requiring confirmation of offset and bore when upgrading.
Bolt pattern details
Below are the core specs most owners and wheel shops reference when upgrading or replacing wheels.
- Number of lug holes: 5
- Pattern diameter: 112 mm (5x112)
- Center bore: 66.6 mm
The combination of a 5x112 lug pattern and a 66.6 mm center bore is the standard fitment for the 2019 Q7’s wheels. Always verify torque specifications and seat type with your dealer or wheel manufacturer before installation.
Compatibility notes
Wheel compatibility can hinge on hub-centric alignment and brake caliper clearance. Most aftermarket wheels in 5x112 will fit if the bore matches or hub-centric rings are used to bridge any mismatch between the hub and the wheel bore. Confirm offset and load rating for your exact vehicle configuration when shopping for replacements or upgrades.
Verification and where to check
To be sure you’re selecting wheels that fit, consult the owner’s manual, contact an Audi dealer, or reference the VIN-specific build sheet. Dealers can confirm center bore, lug nut specifications, and any trim-specific differences that could affect fitment.
Summary
The 2019 Audi Q7 uses a 5x112 bolt pattern with a 66.6 mm center bore. This configuration is widely supported by Audi and VW Group wheels from that period, but buyers should verify offset, bore matching, and torque requirements for safe installation.