Short answer: The bolt pattern is 5 on 114.3 mm (5x114.3) with a 64.1 mm center bore.
The 2000 Honda Accord 4-cylinder, part of the sixth-generation lineup (1998–2002), uses a standard five-lemale wheel hub with a 114.3 mm bolt circle. This pattern is common across most trims from that era, though exact wheel fit can vary with aftermarket parts. The hub’s center bore is 64.1 mm, and lug nuts are typically M12x1.5 with a 60-degree conical seat, depending on the wheel design.
Bolt pattern specifics
Below are the key measurements you should verify when selecting wheels or adapters for a 2000 Accord 4-cylinder.
- Bolt pattern: 5 bolts on a 114.3 mm bolt circle (5x114.3)
- Center bore: 64.1 mm
- Stud size: typically M12 with a 1.5 mm thread pitch (12x1.5)
- Lug nut seat: usually 60-degree conical seat (may vary with wheel design)
These dimensions cover the most common factory and aftermarket configurations for this model year. Always confirm by measuring the hub or consulting the wheel manufacturer to ensure a proper, safe fit.
Additional considerations
When swapping wheels, also account for offset, width, and compatibility with Brem or ABS systems if applicable. Some aftermarket wheels may require hub-centric rings or specific lug nuts to ensure proper alignment and seating. If in doubt, consult a professional or reference the vehicle’s documentation and the wheel specification sheet.
Summary
For a 2000 Honda Accord 4-cylinder, expect a 5x114.3 bolt pattern with a 64.1 mm center bore. The typical lug nut size is M12x1.5 with a 60-degree conical seat, but always verify against your exact wheel and hub setup before purchasing or mounting wheels.