What headlights does a 2006 F250 take?

The 2006 Ford F-250 Super Duty commonly uses two separate halogen bulbs per headlight: a low-beam bulb and a high-beam bulb. On most US-spec models, this means low beam H11 and high beam 9005 (HB3) bulbs for each headlight assembly.

In practice, most 2006 F-250s with factory halogen headlights have a two-bulb setup per side. If your truck has aftermarket headlights or has had prior repairs, the bulb types can vary, so it’s wise to verify by inspecting the current bulbs or checking the owner’s manual for your exact trim and region.

Standard bulb specification

The following bulb types are standard for most 2006 F-250 Super Duty models equipped with factory halogen headlights.

• Low beam bulb: H11


• High beam bulb: 9005 (HB3)

When replacing bulbs, handle them with clean gloves to avoid transferring oils from skin to the glass, and consider replacing both sides at once to maintain consistent illumination.

How to replace bulbs

The steps below describe the typical process for factory halogen headlights on the 2006 F-250. A preface: you’ll want to verify your exact headlight housing before starting, as some trims or aftermarket assemblies can differ.

1. Open the hood and locate the back of each headlight assembly.


2. Disconnect the electrical harness from the bulb by pressing the release tab and pulling straight out.


3. Remove the old bulb by turning it slightly counterclockwise (or releasing any retention clip, depending on the housing).


4. Insert the new bulb, align with the housing, and reconnect the harness.


5. Test the headlights before closing the hood, then reattach any covers or screws.

Note: If your vehicle uses additional parking light or turn signal bulbs within the same assembly, those bulb types will be separate from the main low/high beam bulbs described above.

Alternative lighting options

Some owners opt for brighter or different beam patterns through HID or LED retrofit kits. These upgrades can require additional components such as ballasts, resistors, or updated housings, and may affect warranty and local regulations. If you pursue an upgrade, ensure it complies with your area’s lighting laws and that the installation maintains proper beam alignment to avoid dazzling oncoming drivers.

For most drivers seeking to maintain stock illumination, the factory halogen setup described here remains the standard configuration for a 2006 F-250.

Summary

In summary, the typical 2006 Ford F-250 Super Duty headlight configuration uses two bulbs per side: low beam H11 and high beam 9005 (HB3). If you’re unsure about your specific truck, double-check by inspecting the current bulbs or consulting the owner’s manual, especially if you have aftermarket headlights or a non-standard trim. Replacing bulbs in matched pairs helps ensure balanced lighting.

What headlight bulb does a 2006 Ford F350 take?

Note: The headlight bulb size for 2005, 2006, and 2007 Ford F-350 models with halogen capsule-style headlights is H13, while models with sealed beam headlights use bulb size 6052.

What headlight bulbs does a 2006 F250 take?

Ford F250 LED/HID Bulb Size Summary

What headlight bulbs are in a 2005 F250?

Ford F-250 Super Duty (2005-2006) Bulb Size Chart

Do I need H11 or 9005?

H11 bulbs are designed for use as low beam headlights, while 9005 bulbs are typically used for high beams. This results in a higher brightness level for the 9005 bulbs compared to the H11 bulbs.