The 2020 Hyundai Kona can use different headlight bulb types depending on the trim and market. In most halogen setups, the low beam is H11 and the high beam is 9005 (HB3). If your Kona is equipped with LED headlights, there are no replaceable bulbs—the LEDs are built into the headlight assembly. Always verify with your owner's manual or the vehicle’s data sticker for your exact build.
Headlight configurations by trim and market
The Kona lineup was sold with varying headlight configurations across regions and trims. Halogen headlights were common on base models, while higher trims often offered LED headlights. This means the specific bulb types can vary based on where the car was sold and which option package you have.
Halogen headlight bulbs
Halogen headlight bulbs
Typical halogen sizes for the 2020 Kona when halogen headlights are installed include the following for primary beams and related lighting.
- Low beam: H11
- High beam: 9005 (HB3)
- Fog lights (if halogen): commonly H11
Note: bulb sizes can vary by region and trim; always verify on your specific vehicle using the bulb label on the socket or the owner's manual.
LED headlights and non-replaceable bulbs
On trims equipped with LED headlights, the light source is a sealed LED module rather than a traditional replaceable bulb. When an LED module fails, service typically involves the headlight assembly through a Hyundai dealership or authorized service center rather than swapping a bulb.
How to identify your headlight type
To determine which bulb type your Kona uses, check the following:
- Consult the owner’s manual under Lighting specifications for your exact model and market.
- Inspect the back of the headlight housing: a replaceable bulb with a socket indicates halogen; a sealed LED module indicates LED headlights.
- Look for a bulb size sticker or label on the headlight assembly or inside the engine bay; cross-check with Hyundai’s parts catalog or your manual.
If you’re still unsure, contact a Hyundai dealer with your VIN to confirm the exact bulb size for your vehicle’s trim and region.
Replacing halogen bulbs: quick guide
If your Kona uses halogen headlights, here is a general guide to replacement. Always refer to your specific manual for model-year nuances and safety notes.
- Park safely, turn off the engine, and let the headlights cool before you start.
- Open the hood and locate the back of the headlight housing; remove any dust cover if present.
- Unplug the electrical connector from the bulb, then release any retaining clip or twist the bulb out per the housing design.
- Install the new bulb, reconnect the wiring, and replace the dust cover.
- Test both low and high beams to ensure proper operation and alignment.
Important: avoid touching the glass of a new halogen bulb with bare fingers, as oils can shorten bulb life. Use a clean cloth or gloves when handling.
Summary
In short: for 2020 Kona models with halogen headlights, the typical bulb sizes are H11 for low beams and 9005 for high beams, with halogen fog lights often using the same H11 size. For LED-equipped trims, bulbs are not replaceable and service is handled through the dealer. Always confirm the exact bulb type for your specific market and trim via the owner's manual or Hyundai dealer using your VIN.