In most North American 2007 Camrys, the low beams use H11 halogen bulbs and the high beams use 9005 halogen bulbs. Fog lights, if your model has them, typically use H11 as well. Some regional trims or optional lighting packages may differ, so always verify with your owner's manual or by inspecting the bulb base in your vehicle.
Overview of the standard bulb setup
The 2007 Camry’s headlight system relies on conventional halogen bulbs for common configurations. The exact bulb sizes can vary by market and trim, so it’s important to confirm the correct bulb type before purchasing replacements.
Bulb types by function
Below is a breakdown of the typical bulb assignments for the standard halogen headlight setup. If your car uses a different configuration, consult the owner’s manual or the bulb label on the headlight housing.
- Low beam (dipped beam): H11 halogen bulb
- High beam (main beam): 9005 halogen bulb
- Fog lights (where equipped): H11 halogen bulb
- Optional HID or alternative setups: Some markets or trims offered HID headlights; if your Camry has HID, bulb replacement details differ and you should refer to the manual for specific bulb codes and procedure
When replacing bulbs, use the correct size for your exact vehicle and trim, and handle bulbs with gloves or a cloth to avoid oils from your skin contacting the glass, which can shorten bulb life.
How to verify the correct bulb for your car
To ensure you’re buying the right bulb for your particular Camry, follow these verification steps before purchasing or replacement.
- Park on a level surface with the engine off and the headlamps cool before you start work.
- Open the hood and locate the headlight assembly; check the bulb label on the base or consult the owner’s manual for the recommended bulb size.
- Access the bulb by removing the dust cover and disconnecting the wiring harness; release the bulb by turning it counterclockwise (or unclip, depending on your model).
- Install the replacement bulb using the same procedure in reverse, avoiding contact with the glass; use gloves or a clean cloth if possible.
- Reconnect the wiring, replace any dust covers, and test the headlights to confirm correct operation and beam alignment.
Bottom line: confirming the exact bulb type for your specific vehicle model year and trim helps prevent incorrect purchases and ensures proper headlight performance.
Regional and trim variations
Bulb configurations can differ based on regional markets and trim levels. The guidance below reflects common configurations, but your car may deviate.
- North American market: Low beam H11, high beam 9005; fog lights typically H11 if equipped.
- Other regions or special trims: Some markets offered different headlight packages or HID headlights; if your Camry has HID, you’ll follow the HID replacement procedures outlined in your manual rather than standard halogen bulb replacements.
If you’re unsure, the quickest route is to check the label on the bulb you remove, inspect the headlight housing for size markings, or consult Toyota’s official service resources for your exact VIN and trim.
Summary
The 2007 Toyota Camry commonly uses H11 low-beam and 9005 high-beam halogen bulbs, with H11 also used for fog lights on models equipped with them. Regional trims and optional lighting packages can affect the exact bulb types, so always verify with the owner’s manual or by inspecting the bulb itself. When replacing bulbs, handle them carefully and ensure you’re using the correct size for your specific vehicle configuration.