The typical OEM setup for most Ford Edge models uses M12 x 1.5 lug studs with a 60-degree conical seating surface, a 19 mm hex lug nut, and a torque around 100 ft-lb (135 Nm). Exact specifications vary by year, trim, and wheel package, so verify your vehicle’s numbers for accuracy.
Common specs you should expect
What follows are the specs most Edge owners will encounter, with notes on how they can vary by year and wheel choice.
- Thread size and pitch: M12 x 1.5 is the most common, but some early models or special wheels may use M12 x 1.25 or M12 x 1.75.
- Seat type: 60-degree conical (acorn) seat is standard on most Ford passenger cars, including the Edge; aftermarket wheels may require a different seat type.
- Nut hex size: OEM lug nuts typically require a 19 mm hex; some wheels use a 13/16" (20.95 mm) hex.
- Torque specification: commonly around 100 ft-lb (135 Nm); many Edge applications specify a range roughly from 90–120 ft-lb depending on wheel package and year.
- Wheel compatibility note: always use lug nuts that match both the seat type and the wheel design to avoid seating or clearance issues.
Using the correct hardware and following the torque specification helps prevent wheel loosening, rotor damage, and safety issues. If your wheel package is aftermarket or different from stock, verify compatibility with your VIN.
How to confirm the exact lug nut specs for your Ford Edge
Follow these steps to determine the precise hardware for your vehicle, especially if you have aftermarket wheels or a different year.
- Check the owner's manual or Ford service data for your VIN to find the exact lug nut size, seat type, and torque.
- Inspect the current lug nuts and wheel to identify the seat type and hex size; measure with a caliper if needed.
- Look for a wheel and tire information label on the door jamb or inside the fuel filler door that may reference lug nut size and torque.
- If in doubt, contact a Ford dealer or a qualified tire/wheel shop with your VIN to obtain the precise specifications.
Accurate verification is especially important when changing wheels or using locking lug nuts, to ensure proper seating and safe torque values.
Notes for aftermarket wheels and wheel locks
When using aftermarket wheels or locking lug nuts, the specifications may differ from OEM. Always choose lug nuts that match the wheel’s seat style and thread pitch, and confirm the correct torque for the combined setup. If you use locking nuts, ensure the key is kept in a safe place to avoid wheel security issues.
Manufacturers may provide VIN-specific torque and seating guidance beyond generic values. When in doubt, rely on the dealership or a trusted service center to confirm the exact requirements for your Edge.
Summary
In general, the Ford Edge uses M12 x 1.5 lug studs with a 60-degree conical seat, a hex size around 19 mm, and a typical torque near 100 ft-lb (135 Nm). Exact numbers depend on year, trim, and wheel package. Always verify with your VIN-specific documentation or a dealer to ensure safe installation and performance.