You can view each tire’s current pressure directly from the Civic’s Tire Pressure Monitoring System (TPMS) display on the instrument cluster, or check it with a handheld gauge and compare to the door placard’s recommended pressure.
View tire pressures using the TPMS/instrument cluster
If your 2015 Civic is equipped with a TPMS readout in the instrument cluster or a simple information display, use the controls on the steering wheel to cycle to the Tire Pressure or TPMS screen. This will show the current pressure for each tire. The exact button sequence can vary by trim, but typically involves the INFO/SEL or DISP button to navigate through the screens.
- Turn the ignition to ON (engine can be off or in accessory mode depending on the model).
- Use the steering wheel controls to bring up the information display and navigate to the Tire Pressure/TPMS screen.
- Read the PSI value shown for each tire (front left, front right, rear left, rear right).
- Note the readings and compare them to the recommended cold tire pressure (found on the driver’s door jamb placard or in the owner’s manual).
If your display does not show individual tire pressures, your trim may only show a TPMS warning light when a tire is low, and you’ll need to either use a gauge or consult the manual for how your specific model reports TPMS data.
Check tire pressures manually with a gauge
- Make sure the tires are cold (driven less than a mile since last sitting).
- Remove the valve stem cap from the tire you are checking.
- Press a tire pressure gauge firmly onto the valve stem and note the pressure in PSI (pounds per square inch).
- Repeat for all four tires, then compare each reading to the vehicle’s recommended cold pressure (the placard on the driver's door jamb lists this value).
- If any tire is low, inflate it to the recommended pressure and recheck all tires.
- Replace the valve caps once finished.
Tip: Always inflate to the recommended cold tire pressure; hot tires will show temporarily higher readings.
What to do if the TPMS warning light is on
The TPMS light indicates at least one tire may be underinflated or there could be a sensor issue. Start by checking and inflating all four tires to the recommended cold pressure. Drive a short distance to allow the system to recalibrate; if the light remains on, have the system inspected by a qualified technician to check sensors and batteries.
Where to find the recommended tire pressure
The official “recommended cold tire pressure” value for the 2015 Civic is listed on the driver’s door jamb placard and in the owner's manual. It can vary by trim and tire size, so always use the placard for your exact vehicle configuration as the authority for inflation targets.
Summary
To see tire pressures on a 2015 Honda Civic, use the TPMS/instrument cluster display if available, or measure with a gauge and compare to the door jamb placard. Regularly verifying tire pressure helps improve fuel efficiency, handling, and tire longevity. If you ever see the TPMS light persist after inflating tires to the spec, seek professional assistance to check for sensor or system faults.