To reset the TPMS light on a Honda Pilot, first bring all tires to the recommended cold pressures shown on the door placard. If your model supports it, use the TPMS reset procedure; otherwise a normal drive cycle will allow the system to relearn automatically. If the light persists after following these steps, there may be a faulty sensor or a tire issue that needs service.
What is TPMS and why resetting matters
The Tire Pressure Monitoring System (TPMS) uses sensors in each wheel to monitor air pressure. When a tire is underinflated or a sensor is replaced, the TPMS light in the instrument cluster will illuminate. A reset or relearn calibrates the system to the current tire pressures and sensor data so you receive accurate warnings again.
Two common reset methods for Honda Pilot
This article covers two main approaches depending on whether your Pilot has a dedicated TPMS reset button or relies on automatic relearn.
Method A — With a TPMS reset button
Use this method if your Pilot has a TPMS reset button located on the lower dash, near the hood release, or inside the glove box. This resets the system to current tire pressures and sensor data.
- Inflate all tires to the recommended cold pressures as listed on the driver’s door placard or owner's manual.
- With the ignition ON and the engine OFF, locate and press (and hold) the TPMS reset button until the TPMS indicator in the instrument cluster blinks or you hear a confirmation chime. Release the button.
- Drive at speeds above 30 mph (50 km/h) for about 10 minutes to complete the relearn process. The light should go out or stop flashing after successful calibration.
If the light remains on after the relearn attempt, check for tire leaks, damaged sensors, or a faulty sensor battery. A professional diagnostic may be needed.
Method B — Without a TPMS reset button (automatic relearn)
Many Pilot models rely on automatic relearn. After inflating to the correct pressures, simply drive normally so the system can recalibrate using the new sensor data. This usually takes a short drive on city roads and highways, typically up to 10-60 minutes of cumulative driving at steady speeds.
- Inflate all tires to the recommended cold pressures (door placard). Ensure the valve stems and caps are intact and the tires are sealed properly.
- Drive the vehicle at highway speeds (roughly 40-60 mph or 60-100 km/h) for at least 10 minutes to allow the system to relearn automatically. If you continue to see the light after this drive, repeat a longer highway drive or consult a shop.
- Check the instrument cluster for the TPMS light going out. If it stays on, there may be a sensor fault or a recent tire patch has affected the sensing.
Note: The exact location of the reset button and the relearn timing can vary by trim and year. If you can't find a reset button or the light behavior differs from what's described, consult your owner's manual or contact a Honda dealer.
What to do if the light stays on or reappears
Persistent TPMS warnings can indicate a slow leak, a faulty sensor, or a dead sensor battery. Inspect tires for punctures or leaks, check valve stems, and have the sensors tested with a TPMS diagnostic tool. If a tire was recently replaced or repaired, ensure the technician performed a TPMS relearn after the work.
Summary
Key takeaways: Always start by inflating tires to the correct cold pressures. If your Pilot has a TPMS reset button, use it and then drive to complete the relearn. If there is no reset button, rely on automatic relearn by driving at steady speeds. If the light persists, seek professional diagnosis to check sensors and tire integrity.