The tire pressure sensor (TPMS) on a 2014 Silverado is reset by inflating all tires to the recommended cold pressures and using either the vehicle’s TPMS relearn option in the Driver Information Center (DIC) or by driving at highway speeds to complete a relearn. If the warning light remains after attempting these methods, there may be a faulty sensor or a leak that requires inspection.
Understanding TPMS on the 2014 Silverado
TPMS monitors each wheel’s air pressure and alerts you when a tire is underinflated. The system can require a relearn after you rotate tires, replace sensors, or service a wheel. Proper relearn ensures the dashboard warning reflects the correct set of sensor data.
Why the TPMS light can come on
Common causes include underinflation, a failed sensor, a battery issue inside a sensor, or a damaged valve stem. After inflating tires, if the light stays on, a relearn or sensor inspection may be needed.
Two approaches to relearn TPMS on the 2014 Silverado
Choose the method that matches your vehicle’s configuration. If you don’t see a TPMS relearn option in the DIC, use the highway-speed relearn described below.
Using the Driver Information Center (DIC) TPMS option (if equipped):
- Ensure all tires are inflated to the recommended cold pressures listed on the door placard.
- Turn the ignition to ON with the engine OFF (or press the start button without pressing the brake).
- Navigate through the Driver Information Center to Vehicle > TPMS > Relearn (the exact menu labels can vary by model year/trim) and select Relearn.
- Follow the prompts to initiate the relearn; the instrument cluster will indicate that the relearn is active.
- Drive at speeds above about 50 mph (80 km/h) for roughly 10 minutes to complete the relearn.
- When the relearn finishes, the TPMS light should stay off. If it continues to flash or remain on, recheck tire pressures and inspect for sensor faults or leaks.
Alternative approach: highway-speed relearn (no DIC option required):
- Confirm all tires, including the tires using TPMS sensors (do not forget the spare if your manual specifies), are inflated to the recommended cold pressures.
- With the vehicle in Park and the ignition ON, drive onto a highway and maintain a steady speed above 50 mph (80 km/h) for at least 10 minutes.
- Avoid abrupt braking or hard cornering during the relearn. The TPMS will relearn the sensors as you drive.
- After completing the drive, check the dashboard; the TPMS light should go out. If it remains, repeat the process or test the sensors for faults.
Concluding note: The DIC method is vehicle-specific and may not appear on all trims. The highway-speed relearn is a universal backup that works on most models when a dedicated relearn option isn’t available.
Troubleshooting and next steps
Check tire pressures and sensor health
Use a reliable tire gauge to verify that all four main tires are at the recommended cold pressures. Look for nails, punctures, or slow leaks. If a tire cannot hold pressure, service or replace it and perform a fresh relearn if needed.
When to seek professional service
If the TPMS light persists after attempting both relearn methods, a professional diagnostic with a TPMS scan tool is advised. A technician can check sensor batteries (typically 5–10 years), inspect for corrosion or wiring damage in the wheel sensors, and verify proper system operation. Note that the spare tire typically does not carry a TPMS sensor on many Silverado configurations, so don’t expect it to participate in a relearn.
Summary
Resetting TPMS on a 2014 Chevy Silverado is usually straightforward: inflate all tires to the recommended cold pressures and perform a TPMS relearn via the DIC if available, or drive at highway speeds to complete a relearn. If the warning persists after attempting both methods, inspect for leaks or faulty sensors and seek professional service to diagnose and fix the system.