To reset the clock on a 2011 Honda Civic, turn the ignition on, press and hold the CLOCK button until the digits flash, then adjust the hours and minutes with the H and M controls, and release to save. If your Civic has a navigation system, you can also set the clock from the NAV display in Settings.
Manual clock setting (no navigation)
If your Civic doesn’t have a built-in navigation system, use the standard clock controls on the center stack to set the time.
- Turn the ignition to ON or ACCESSORY so the instrument panel and clock display activate.
- Press and hold the CLOCK button until the clock digits begin to flash on the display.
- Use the H button (hours) to advance to the correct hour. If your model uses a different control, use the equivalent hour-setting control (often a knob or +/- button).
- Use the M button (minutes) to advance to the correct minute. Again, if your model uses a different control, use the corresponding minutes control.
- Release the CLOCK button or wait about 5 seconds for the new time to be saved and the digits to stop flashing.
After resetting, verify the time is accurate and adjust for AM/PM if your display shows it. Some trims may show a 24-hour format on certain screens.
Clock setting with navigation system
If your Civic is equipped with factory navigation, the time is typically set through the NAV display rather than the clock button.
- Turn the ignition ON and wake the navigation screen.
- Open the Settings or System Settings menu, then select Clock or Time.
- Use the on-screen controls to set the hour and minute, then confirm your selection.
- Exit the settings and confirm that the dash clock reflects the updated time.
Because software versions vary, the exact menu labels may differ (for example Settings > Clock or Settings > Time). If in doubt, look for Clock under Settings or System Settings.
Troubleshooting and tips
If the clock won’t reset or the display doesn’t respond, try these steps to troubleshoot the issue.
- Ensure the ignition is in the ON position and the vehicle’s electrical system is awake; some models require ACC or the engine running to power the clock controls.
- Double-check you’re using the correct controls for hours (H) and minutes (M) or the appropriate on-screen controls for NAV models.
- If the time still won’t change, turn the ignition off, wait a few seconds, and try again to restart the clock control cycle.
- Persistent issues may indicate a low battery, a blown fuse, or a software/clock module problem; if trouble persists, have the system checked by a qualified technician.
In most cases, following these steps will restore the correct time without requiring professional service.
Summary
Resetting the 2011 Honda Civic clock is straightforward: non-navigation models use the CLOCK button with hour (H) and minute (M) controls to set the time, while NAV-equipped models can set the clock through the Settings or NAV menu. If problems arise, check ignition state, battery health, and fuses, and consult the owner's manual for trim-specific differences.
How to set the clock on a 2011 Honda Accord?
So right here we see a huge button that says clock. So we press and hold this. Button. Now the clock is blinking.
How do I change the time on my 2011 Honda?
And bang done that's how you do. It. All right so right now we're sitting inside a 2011 Honda Cord SE for special edition you can see the clock right up here on the center display.
How to reset the clock on a 2011 Honda CR-V?
This you're going to hold. This. See right there you hear that beep it's time to change it now if go down here you see the one two three this is the hours minutes and reset once If you reset.
How do I change the clock time on a 2010 Honda Civic?
And you turn the car. On. You hold the clock. Button down until it starts flashing until the clock starts flashing it usually one or two seconds. And you can see it flashes.