To reset the clock on a 2007 Honda Accord, turn the ignition to ON or ACC, press and hold the CLOCK button on the radio until the hours blink, then adjust the hours with the H (hour) control and the minutes with the M (minute) control, and press CLOCK again to save. If your model has a navigation system or a different display, the clock may be adjusted through those menus instead.
Step-by-step clock reset
Follow these steps to set the clock on most non-navigation 2007 Accords.
- Turn the ignition to ON (or ACC) and turn on the radio if needed.
- Locate the CLOCK button on the radio or dashboard display.
- Press and hold the CLOCK button until the hour digits begin to blink.
- Use the H (hour) button (or the +/− or HR control) to set the correct hour.
- Use the M (minute) button (or MN) to set the correct minutes.
- Press the CLOCK button again to confirm the time, or wait for the blinking to stop to save automatically.
- Turn off the ignition and restart to verify the clock is correct.
Note: The exact labeling can vary by trim. Some models require tapping the H and M buttons instead of holding CLOCK.
In most cases, the set time will remain until you reset it again. If the clock reverts after you start the engine, proceed to the troubleshooting section below.
Alternate methods for nav-equipped models
Some 2007 Accords with a factory navigation system or advanced display manage the clock through the navigation menu rather than the radio clock button.
- Power on the navigation screen and access the Settings or System option.
- Find Clock or Time; adjust hours and minutes; confirm to save.
- Exit back to the main screen and verify the time is correct.
Note: In some cases the GPS time is synchronized automatically. Manual adjustments may be available if you travel across time zones or if GPS timing is temporarily unavailable.
If your vehicle uses GPS time, allow a moment for the system to update after you confirm changes. If it doesn’t update as expected, consult the owner’s manual for navigation-specific steps.
Troubleshooting
Clock won’t enter setting mode
Ensure the ignition is in ON or ACC and the radio is powered. If the CLOCK button does not cause the hours to blink, try a longer press or refer to the navigation/manual instructions for your trim. A blown fuse or memory power issue could also prevent clock settings from sticking.
Time resets after restarting the car
This can happen if the vehicle’s 12-volt battery or the memory power line has been interrupted. Check the battery health and any memory fuses. After power is restored, you may need to re-enter the clock settings again.
Summary
Resetting the 2007 Honda Accord clock typically involves turning the ignition on, pressing and holding the CLOCK button, and adjusting the hours and minutes with dedicated controls before saving the new time. On models with navigation, use the Settings or Clock menu to adjust. If problems persist, consult the owner’s manual or contact a Honda dealer for assistance.