Inflate all tires to the recommended cold pressures, then use the car’s TPMS relearn procedure—either a Set/Reset button if equipped or an automatic relearn achieved by driving—to reset the system on a 2011 Honda Accord.
Understanding TPMS in the 2011 Accord
The Tire Pressure Monitoring System (TPMS) in the 2011 Honda Accord monitors each wheel’s air pressure and alerts you when a tire is underinflated. After inflating tires to the correct cold pressures, the system may require a relearn so it can recognize the new pressures and sensor IDs. If the warning light stays on after inflation and possible relearn attempts, there may be a faulty sensor, a damaged valve stem, or a sensor battery issue.
Reset options for the 2011 Honda Accord
Using a Set/Reset button (if equipped)
If your particular 2011 Accord has a dedicated TPMS Set/Reset button, follow these steps to relearn the sensors:
- Inflate all tires to the recommended cold pressures listed on the door jamb sticker or in the owner’s manual.
- Turn the ignition to ON with the engine off.
- Find the TPMS Set/Reset button. It is commonly located under the left side of the dash, near the steering column, or inside the glove box area depending on trim. Press and hold the button until the TPMS indicator light flashes or changes state (often blinking once or twice).
- Release the button and drive the vehicle at 50 mph (80 km/h) or higher for about 10 minutes to complete the relearn.
- Turn the ignition off, then start the engine and verify the TPMS light remains off after a short drive.
Note: If the light does not respond as described or you cannot locate a Set/Reset button, proceed with the automatic relearn method described below or consult the owner’s manual for the exact location of the TPMS controls on your trim.
After using the Set/Reset procedure, the system should accept the new tire pressures and sensor IDs. If the warning persists, recheck tire pressures and consider inspecting sensors or seeking professional service.
Automatic relearn (no Set/Reset button)
Some 2011 Accords without a dedicated TPMS button rely on an automatic relearn process. Follow these steps if you don’t have a reset button:
- Inflate all tires to the correct cold pressures as indicated on the door jamb sticker.
- Turn the ignition to ON with the engine off.
- Drive straight for about 10 minutes at a steady speed between 40–50 mph (64–80 km/h). The system will relearn the new tire sensor positions during this drive.
- Check that the TPMS warning light goes off after driving; if it stays on, try a longer highway drive or repeat with all tires at proper pressures.
If the light remains on after an automatic relearn, the issue could be one of the following: a damaged or leaking tire, a faulty sensor, a failing battery in a sensor, or a sensor that needs reprogramming. In such cases, seek professional service or use a diagnostic tool at a shop to pinpoint the problem.
Troubleshooting tips
- Always verify all four tires are inflated to the recommended cold pressures before attempting a relearn.
- Check for any tire punctures or slow leaks that could cause fluctuating pressures after reset.
- Inspect valve stems and wheel sensors for damage or corrosion, especially after tire work or wheel changes.
- If you recently fitted new tires or wheels, a TPMS relearn is often required.
- When in doubt, consult a Honda dealer or a qualified tire shop equipped with a TPMS relearn tool.
Professional diagnosis is recommended if the TPMS warning light continues to illuminate despite correct pressures and attempted relearns, as sensor faults or wheel hardware issues may be present.
Summary
Resetting TPMS on a 2011 Honda Accord typically involves inflating all tires to the specified cold pressures and using either a Set/Reset button (if equipped) or an automatic relearn by driving at highway speeds. If issues persist after attempting relearn methods, check for leaks, sensor damage, or consult a professional to diagnose sensor or wheel problems. Maintaining proper tire pressure not only helps the TPMS function properly but also enhances safety and fuel efficiency.
Why doesn't my Accord have a tire pressure monitor reset button?
You need to replace the sensor. And the tire dealer should be able to program those to the ECU. For you for 2013 to 2016 Honda Accord owners.
How do you reset the TPMS on a 2011 Honda Accord?
Push the Reset button near your steering wheel or navigate to Vehicle Settings on your infotainment screen. Tap TPMS Calibration followed by Calibrate. Your system should calibrate, and your Honda TPMS light should turn off within 20 to 30 minutes of normal driving.
Where is the TPMS reset button on a Honda Accord?
Key. Then we reach down below to our tire pressure moni monitoring system switch. We push and hold for 3 seconds. And you'll see your light has gone out and the system is in the recalibration mode.
How to turn off TPMS light Honda 2011?
Some older Honda models include a TPMS button on the left side of the steering wheel. If your vehicle has this, you can simply press and hold the button, waiting to make sure the light blinks twice. Otherwise, as with the newer models, how you'll reset the TPMS light depends on whether or not you have a touchscreen.