Reset the maintenance light on a 2013 Toyota Tacoma using the odometer/trip reset button and the ignition sequence—no tools required.
What the maintenance light means
The maintenance reminder (often labeled MAINT or Maintenance Required) signals that scheduled service is due, such as oil changes or other routine maintenance. It’s reset after the maintenance is completed so the driver receives the next interval reminder. If service has not yet been performed, do not reset the light—perform the required maintenance first and then reset.
Reset procedure
Use the following sequence to clear the MAINT light. The notes below explain the intent of the steps and ensure you’re performing the reset correctly.
- With the ignition in the ON position and the engine OFF, verify the odometer display is showing the total mileage (ODO) rather than Trip A or Trip B.
- Turn the ignition OFF.
- Press and hold the odometer/trip reset button (the knob near the speedometer).
- While continuing to hold the reset button, turn the ignition back to ON (engine still OFF).
- Keep holding the button for about 5–10 seconds, until the odometer display returns to normal or the MAINT light goes out, then release the button.
- Turn the ignition OFF, then start the engine to verify the MAINT light is no longer illuminated.
After completing the sequence, the maintenance reminder should be reset and will reappear at the next scheduled interval after the service is due. If the light does not reset after several attempts, consult the dealership or the owner’s manual for model-specific guidance, as variations can occur by trim level or due to battery/disconnect events.
Notes and alternatives
Some vehicle owners report slightly different phrasing or timing in the reset process depending on regional specs or minor year-to-year changes. If your Tacoma doesn’t respond to the above steps, try repeating the sequence once more, ensuring you start from the exact display (ODO) and that the ignition is fully in the ON position with the engine off during the reset operation. If problems persist, a quick visit to a Toyota service center can confirm there are no underlying issues with the reminder system.
Tips for a smooth reset
- Perform maintenance first: resetting is meant to coincide with a completed service. - Make sure you’re using the correct display (ODO) during the reset. - If the vehicle has a recently disconnected battery, you may need to repeat the steps or drive briefly after the reset to reinitialize the system.
Summary
To reset the 2013 Toyota Tacoma maintenance light, use the odometer/trip reset button with the ignition sequence described above. Ensure the service has been completed, follow the steps carefully, and verify the light is extinguished by starting the engine. If issues persist, seek guidance from a Toyota service professional.