The Dodge Charger’s power windows can lose calibration, causing auto-down or auto-up to stop working. Resetting the driver’s window usually fixes it: fully lower, then fully raise the window and hold the switch briefly after it closes to relearn the upper limit. The exact steps can vary by year and trim, so check your manual if this doesn’t work.
The following guide outlines a practical, newsroom-ready approach to recalibrating the window system. It covers the standard driver’s-side procedure and, where applicable, how to reset other windows. Always exercise caution to avoid injury or damage to the glass and mechanism.
Understanding the Dodge Charger window system
Power windows in the Charger operate with a motorized regulator and an electronic control module that learns the window’s upper and lower limits. When the system loses its learned positions—often after battery disconnection or a fault—the auto up/down feature can fail or behave erratically. A reset reinitializes the memory so the windows move to the correct endpoints again.
Year-to-year variations
Most Chargers share a similar reset concept, but timing and exact steps can differ by generation. Models from early generations (e.g., pre-2011) may require slightly different hold times or sequence. If in doubt, consult the owner’s manual or contact a Dodge service center for model-specific instructions.
Driver’s window reset: step-by-step
Use this procedure to recalibrate the driver’s window, which commonly governs the auto up/down behavior for the front right and left doors.
Before starting, park safely, turn the ignition to ON, and clear the window path of any obstructions.
- Turn the ignition to the ON position (engine off) and ensure the driver’s window switch works.
- Fully lower the driver’s window by pressing the switch all the way down, then release when it reaches the bottom.
- Raise the window all the way up by pulling the switch up, and continue to hold the switch in the up position for 2–3 seconds after the window closes.
- Release the switch and test the auto function by giving a quick, one-touch press to the window switch to see if it moves automatically.
The driver’s window reset is now complete. If the auto-up function does not engage after this reset, try the steps again or check for obstructions, wiring issues, or fuse problems.
Resetting other windows
Some Charger configurations allow per-window calibration for rear windows. If your model supports it, you can repeat the same sequence on each window to enable their auto up/down features.
- With ignition ON, operate each rear window switch fully down to the bottom and release.
- Raise the same window fully to the top and hold the switch in the up position for 2–3 seconds after it closes.
- Repeat for any remaining rear windows as needed.
After completing the per-window resets, test all auto functions. If any window still lacks auto up/down or anti-pinch performance, there may be a hardware fault requiring professional inspection.
What to do if the reset doesn’t work
If the reset does not restore proper function, inspect or replace components as needed. Check these common culprits: battery connections, related fuses, the window motor and regulator assembly, and the door control module. If available, run a vehicle diagnostic to detect module faults or sensor issues. Always prioritize safety when working around powered glass.
Summary
Resetting the Dodge Charger’s windows is a straightforward calibration task that typically involves fully lowering and then fully raising the affected window, then holding the switch briefly after it closes to relearn the upper limit. While the general method is shared across many model years, exact timing and steps can vary—consult your owner’s manual or a Dodge service professional for your specific year and trim. If issues persist after a reset, pursue a professional diagnosis to check for regulator, motor, or control-module faults.
How to reset dodge window?
Again. Let it go all the way down. And then all the way up. And when it's all the way up hold it for 5 seconds. Two three four five and now I'm ready to roll that is how you reset the windows.
Why is my Dodge Charger window not going up?
The most common reasons a Dodge Charger window won't go up or down are window's electrical system such as a fuse or relay, a broken window motor, or a broken window regulator.
Can I manually raise a power window?
A power window is a motorized window that can be raised or lowered using a switch. In the event of a power failure or switch malfunction, it may be necessary to manually raise a power window. There are two common methods for manually raising a power window: using the window crank or using the manual override.
How to reset power window system?
Down. And hold the button down for 5 seconds. And then pull it all the way up. And once it's all the way up hold the button for 5 seconds and that reprograms it hope that helps.