The quickest way to reset the tire pressure light is to inflate all tires to the recommended cold pressures and drive above about 50 mph for roughly 10 minutes to relearn the sensors. If your trim supports it, a TPMS reset button can also be used as an alternative method.
In a 2016 Honda Fit, the Tire Pressure Monitoring System (TPMS) uses sensors in each wheel to alert you when a tire is underinflated. The light is designed to come on when pressures drop below the safe threshold and to reset once the system detects proper pressures again. If the light stays on after inflating, the system may need to relearn, or there could be a sensor issue.
Not all trims include a dedicated TPMS reset button, and procedures can vary slightly. The steps below cover the common home reset methods for the 2016 Fit.
Reset methods: driving relearn and button option
Below is the standard approach you can try at home. The steps are intended to guide you through inflating to the correct pressures and the relearn process, with an alternative button method if your model supports it.
- Check all tires and inflate them to the recommended cold pressures listed on the door jamb sticker. Make sure tires are cold before measuring.
- After inflating, start the engine and drive at speeds over 50 mph (80 km/h) for about 10 minutes to allow the TPMS to relearn the new pressures.
- If your 2016 Fit has a TPMS reset button, locate it (often near the left side of the driver's knee panel or under the dash). Press and hold the button until the TPMS indicator light blinks or goes out, then continue driving to complete the relearn.
- If the light remains on after performing the above steps, inspect each tire for slow leaks, damage, or a faulty sensor. Note that the spare tire usually isn’t part of the TPMS, so issues there won’t reset the system. If in doubt, have a professional check the sensors and system.
In summary, the typical reset process involves ensuring correct tire pressures, a short drive to relearn, and using a TPMS button if your trim supports it. If the light persists, the issue may be a slow leak or a faulty sensor requiring diagnostic service.
Model-specific notes for the 2016 Honda Fit
Using the TPMS reset button (if equipped)
Some trims include a TPMS reset button located under the dashboard or near the steering column. If your vehicle has one, press and hold the button as directed in your owner's manual until the light blinks or turns off, then continue driving to complete the relearn cycle.
Automatic relearn by driving
If no reset button is present, rely on the automatic relearn procedure: after inflating to the correct pressures, drive at highway speeds for about 10 minutes to allow the system to reacquire sensor data and update the light status.
Troubleshooting tips
Always recheck tire pressures when the ambient temperature changes, as cold-to-warm transitions can affect readings. If the TPMS light reappears after a successful reset, there may be a slow leak or a failing sensor that needs diagnostic testing at a tire shop or Honda service center.
Summary
Resetting the TPMS light on a 2016 Honda Fit mainly involves inflating all tires to the recommended cold pressures and performing a relearn drive. If equipped, a TPMS reset button can expedite the process. If the light stays on, investigate tire leaks or sensor problems with professional assistance to ensure accurate monitoring and safe driving.