Skip to Content
103 State St East Jordan, MI, 49727
  • MON: Closed
  • TUES: 8:00AM - 6:00PM
  • WED: 8:00AM - 6:00PM
  • THUR: 8:00AM - 6:00PM
  • FRI: 8:00AM - 6:00PM
  • SAT: Closed
  • SUN: Closed
MORE >
  • Yelp
  • Google Business Profile
  • Facebook
7984 North St Central Lake, MI, 49622
  • MON: 8:00AM - 6:00PM
  • TUES: 8:00AM - 6:00PM
  • WED: 8:00AM - 6:00PM
  • THUR: 8:00AM - 6:00PM
  • FRI: Closed
  • SAT: Closed
  • SUN: Closed
MORE >
  • Yelp
  • Google Business Profile
  • Facebook

How much oil to put in a 2017 Honda HRV?

A 2017 Honda HR-V with the 1.8-liter engine requires about 3.7 quarts (3.5 liters) of engine oil for a full change with the filter.


The recommended oil grade is 0W-20 full synthetic. Capacity figures can vary slightly if the filter differs or if you’re not performing a filter change, so always confirm by checking the dipstick after filling.


Oil capacity and recommended oil


Key capacity figures for the HR-V’s 1.8L engine are shown here:



  • Oil capacity with a new filter: 3.7 quarts (3.5 liters)

  • Oil capacity without the filter: about 3.5 quarts (3.3 liters)


Once you’ve filled, check the oil level with the dipstick and adjust as needed to reach the full mark. Always use the recommended oil type for optimal lubrication and engine health.


Oil grade and service interval


To keep the engine properly lubricated, use the following guidelines:



  • Recommended oil: 0W-20 full synthetic (Honda Genuine or equivalent)

  • Service interval (normal driving conditions): roughly every 7,500 miles or 12 months, whichever comes first

  • Severe service interval (extreme conditions, frequent short trips, extreme heat/cold): about every 3,750–5,000 miles or 6 months


Actual intervals can vary based on climate and driving habits. Always consult the owner’s manual for the exact schedule for your vehicle and market.


How to check and fill oil correctly


Before starting, assemble the necessary supplies and ensure the car is on level ground with the engine cool. The following steps outline a typical oil fill and check process:



  1. Park on level ground, engine off, and allow it to cool for a few minutes.

  2. Remove the oil filler cap on top of the engine to vent while pouring.

  3. Slowly add oil in small increments (about 0.5 quart at a time) and wait a moment for it to settle.

  4. Check the level with the dipstick, wiping it clean first, then reinsert and pull out to read the full line.

  5. If the level is below the full mark, continue adding small amounts and rechecking until it reaches the Full line. Do not overfill.

  6. Run the engine briefly, turn it off, and recheck again after a few minutes of settling to confirm the correct level.


Safety note: Use proper jacking and support if you lift the vehicle for a drain; dispose of used oil according to local regulations.


Summary


For a 2017 Honda HR-V, plan to add about 3.7 quarts (3.5 liters) of 0W-20 full-synthetic oil during a full change with a filter, and verify the level with the dipstick after filling. Follow the recommended service interval—7,500 miles/12 months under normal conditions (shorter intervals under severe service). Always refer to the owner’s manual for model-year and market-specific guidance.

Related Articles

Ryan's Auto Care

Ryan's Auto Care - East Jordan 103 State St East Jordan, MI 49727 231-222-2199
Ryan's Auto Care - Central Lake 7984 North St Central Lake, MI 49622 231-544-9894

Ask any car or truck owner in Central Michigan who they recommend. Chances are they will tell you Ryan's Auto Care.