About 7.6 quarts (7.2 liters) of engine oil with a new filter; roughly 7.0 quarts (6.6 liters) if you’re not replacing the filter.
The 2004 Toyota Tundra SR5 uses the 2UZ-FE 4.7-liter V8. Oil capacity figures can vary slightly depending on the filter and drain conditions. This article outlines the official figures, how to verify the oil level, and best practices for maintenance.
Engine and Capacity Basics
The 2004 Tundra SR5 is powered by the 2UZ-FE 4.7L V8. Published oil capacity assumes a drained pan and a new oil filter; real-world variations may occur with different filter sizes or aftermarket parts.
Official Oil Capacity for the 2004 Tundra SR5
To help plan oil changes, here are typical capacity figures published for the 2UZ-FE engine. Actual capacity can vary slightly by filter design and pan variations.
- Oil capacity with a new oil filter: 7.6 quarts (7.2 liters)
- Oil capacity without replacing the filter: approximately 7.0 quarts (6.6 liters)
In practice, budgeting around 7.5 quarts accounts for filter volume and small variances. Always verify the oil level with the dipstick after a drain and fill.
Oil Type and Change Interval
Viscosity and Brands
Most 2UZ-FE engines, including the Tundra's V8, call for 5W-30 engine oil in standard U.S. temperatures. In hotter climates or with older engines, 10W-30 can be used. Synthetic blends are acceptable; use oil that meets or exceeds API service standards specified in the owner's manual.
Maintenance Intervals
Oil-change intervals typically range from 5,000 miles (8,000 km) for conventional oil under normal driving, to 7,500 miles (12,000 km) with high-quality synthetic oils or favorable conditions. Severe driving conditions may require 5,000-mile intervals. Follow the official maintenance schedule in your manual.
How to Check and Top Up Oil
Use these steps to ensure the oil level is correct after an oil change or topping up:
- Park on level ground and wait 5–10 minutes for oil to settle.
- Remove the dipstick, wipe clean, reinsert, then pull out to check the level. The oil should be between the Min and Max marks.
- If low, add small amounts of oil, rechecking after each addition. Do not overfill.
- Replace the dipstick and close the hood securely.
As a baseline, start with about 7.6 quarts when changing the oil with a new filter, and adjust based on the dipstick readout.
Summary
The 2004 Toyota Tundra SR5 with the 4.7L V8 (2UZ-FE) typically requires about 7.6 quarts (7.2 liters) of engine oil when changing the oil with a new filter, with roughly 7.0 quarts (6.6 liters) if you’re not replacing the filter. Use 5W-30 in most climates and follow Toyota’s recommended maintenance intervals. Always confirm the level with the dipstick after filling.