For a full oil change on a 2008 Honda Accord with the 3.0-liter V6, you should plan for about 5.5 quarts (roughly 5.2 liters) of engine oil when you replace the filter. If you do not replace the filter, the capacity is closer to 5.0 quarts. After adding oil, always verify the level with the dipstick and adjust as needed.
Official specifications and recommended oil
The 2008 Accord V6 uses the J30A engine. Honda lists an oil capacity of 5.5 quarts (5.2 liters) with a new oil filter. The recommended oil viscosity for most driving conditions is 5W-20; in very hot climates or under heavy-load conditions, 5W-30 may be acceptable per the owner's manual. Always confirm the exact specification for your vehicle’s VIN in the manual or Honda's service resources.
Key capacity figures to know for planning a change:
- With a new oil filter: 5.5 quarts (about 5.2 liters)
- Without changing the filter: about 5.0 quarts (about 4.7 liters)
Note: These numbers assume standard filter sizes and typical engine wear. Actual amounts can vary slightly depending on the filter model and engine condition.
Practical steps for an oil change
If you’re performing the oil change yourself, here are the typical steps and expectations to ensure a correct fill and safe operation:
- Gather supplies: 5W-20 oil, a new oil filter, a drain pan, a funnel, a wrench, and a jack and stands on a level surface.
- Warm up the engine briefly, then turn it off and safely raise the car to access the drain plug.
- Drain the old oil completely, replace the drain plug with a new gasket if needed, and remove the old oil filter.
- Install the new oil filter and add the recommended amount of oil (about 5.5 quarts with the filter installed).
- Start the engine, run for a minute to circulate the oil, then turn off and recheck the level with the dipstick. Top up to the full mark if necessary.
After the change, dispose of used oil responsibly and note the service date and oil specification in your maintenance log.
Notes and caveats
Always verify the exact specification for your vehicle’s VIN in the owner’s manual or Honda’s online resources. Some markets or engine variations may show minor differences. A quick dipstick check after a warm engine will yield the most accurate reading.
Summary
The 2008 Honda Accord V6 requires about 5.5 quarts (roughly 5.2 liters) of engine oil for a full change with a new filter, using 5W-20 viscosity. If you don’t replace the filter, expect around 5.0 quarts. Always confirm the correct amount by checking the dipstick after filling, and consult the owner’s manual for your specific VIN and climate considerations.
What year is the fastest V6 accord?
2004
The fastest Honda Accord ever was a 2004 V6 model, which delivered a 0-60 mph time of just 5.9 seconds.
What is the weakness of the Honda Accord?
This powertrain shines in sport and touring trims providing a balance of power and smoothness that rivals European sedans hybrids with their 2.0 L Atkinson cycle engine and ECVT excel in fuel economy.
How much oil does a 2008 4.3 L V6 take?
Capacity: 4.5 quarts (with filter). After refill check oil level.
How much oil does a 2008 Honda Accord V6 need?
Oil Grade: API*
| Viscosity: | 5W-20 (All TEMPS) |
|---|---|
| Capacity: | 4.5 quarts (with filter). After refill check oil level. |
| Capacity: | 4.2 quarts. w/of. After refill check oil level. |
| Torque: | 29 ft/lbs (Oil Drain Plug) |