Approximately 3.7 US quarts (3.5 liters) of engine oil, including the filter, is typical for a Honda Fit 1.5L during an oil change. This article explains the capacity, recommended oil type, and best practices for checking and changing the oil across the Fit's main generations.
The 1.5-liter i-VTEC engine used in Fit/Jazz models across generations generally shares this fill capacity, but exact numbers can vary by market and year. Always consult the owner's manual or dealer service publications for your specific vehicle. Below are the typical figures and practical guidelines for owners and DIY enthusiasts.
Oil capacity across generations
The official capacity for the 1.5L Fit engine is published as about 3.7 quarts (3.5 liters) with a filter. The following list captures the commonly cited figures by generation, noting that regional variations can occur.
- First generation (roughly 2007–2014, Jazz/Fit across many markets): 3.7 quarts (3.5 L) with oil filter
- Second generation (roughly 2014–2020): 3.7 quarts (3.5 L) with oil filter
- Third generation (roughly 2020–present): 3.7 quarts (3.5 L) with oil filter
These figures are listed with the oil filter included. If you are not replacing the oil filter, the system will require slightly less oil to reach the correct level; always verify on the dipstick after filling.
Regional considerations
In some countries, specs may vary slightly depending on the engine variant or local service bulletins. Always confirm the correct capacity for your exact market and model year with the owner's manual or a Honda dealer.
Oil type and viscosity
Choosing the right oil grade is essential for performance and longevity. Honda's recommendations for the 1.5L Fit typical markets emphasize synthetic oil with a lightweight viscosity.
- 0W-20 full synthetic engine oil is the standard recommendation for most Honda Fit 1.5L engines in North America and many other regions.
- In some markets or under specific climate conditions, alternatives such as 5W-20 or 0W-30 may be acceptable; always follow your owner's manual or your dealer's guidance.
Using the recommended oil grade helps maintain fuel efficiency and engine protection. If your climate is hot or you routinely drive in severe conditions, discuss any approved alternative viscosities with a dealer.
Climate and usage notes
Extreme temperatures or aggressive driving can influence oil choice. While 0W-20 is standard for many Fits, a dealer can confirm if your local climate suggests an alternative approved viscosity.
Practical maintenance tips
Beyond knowing the capacity and grade, proper maintenance ensures optimal engine health and performance. The following guidelines help you manage oil changes and checks.
Check oil level: After warming up the engine, turn it off for a few minutes, then pull the dipstick, wipe, reinsert, and check the level between the MIN and MAX marks. If low, add small amounts of oil gradually, rechecking to avoid overfill.
Change interval: For synthetic oil, Honda commonly recommends oil changes at roughly every 5,000–7,500 miles (8,000–12,000 km) under normal driving conditions. In severe or frequent short-trip driving, shorten this interval per the owner's manual.
Summary
The Honda Fit 1.5L engine typically takes about 3.7 quarts (3.5 liters) of engine oil with a filter during an oil change. Use 0W-20 full synthetic in most regions, verify exact requirements in your manual, and follow the recommended maintenance intervals to keep the engine running smoothly.