A 4.0-liter Town & Country typically takes about 5 quarts of engine oil when performing a standard oil change with a new filter.
The 4.0L PowerTech V6 used in Town & Country models from roughly the late 1990s through the mid-2000s generally lists an oil capacity of five quarts (about 4.7 liters) with the filter. Always verify the exact specification for your year in the owner's manual or by checking the dipstick after filling.
Oil capacity and related details for the 4.0L Town and Country
Understanding the capacity helps with planning maintenance and ensuring you don’t under- or overfill. The 4.0L engine shares a similar fill volume with other Mopar V6s of its era, but always use the oil type and quantity recommended by Chrysler for your specific year and configuration.
Key facts you should know at a glance:
- Oil capacity with a new filter: 5 quarts (4.7 liters).
- Recommended oil viscosity typically 5W-30 or 5W-20 depending on climate and model year; always check the owner's manual.
- Always replace the oil filter when changing oil to maintain proper filtration and capacity.
In short, plan for about five quarts of oil when performing a full oil change on the 4.0L Town & Country, assuming you also replace the filter.
How to perform an oil change on the 4.0L Town and Country
Here is a practical step-by-step outline for a typical oil change on this engine:
- Warm up the engine, then park on a level surface and apply the parking brake.
- Allow the engine to cool for a few minutes, then place a drain pan beneath the oil pan and remove the drain plug to let the oil drain completely.
- Remove the old oil filter and prepare the new filter by lightly oiling its gasket.
- Install the new oil filter and reinstall the drain plug securely.
- Open the hood and remove the oil fill cap, then add the recommended amount of oil (about 5 quarts for a typical change).
- Start the engine and run for a minute, then turn off and check for leaks.
- Let the engine rest for a few minutes, then check the oil level with the dipstick and add oil as needed to reach the full mark.
Following these steps will help ensure you’ve added the correct amount of oil and achieved an accurate level reading after the change.
Note on model year variations
While the five-quart figure covers most Town & Country 4.0L applications, there can be slight variations by model year and drivetrain. If in doubt, consult your owner's manual or contact a Chrysler service advisor for the exact specification for your vehicle.
Additional guidance: oil grade and maintenance tips
Always use the oil grade recommended by Chrysler for your engine and climate. In many cases, 5W-30 is a standard choice, with 5W-20 used in certain climates or newer guidelines. Confirm the precise specification for your specific year and region to maximize engine longevity and performance.
Summary
The Chrysler Town & Country's 4.0L V6 typically requires about 5 quarts (4.7 liters) of engine oil when changing the oil and replacing the filter. Always verify the exact capacity for your year in the owner's manual, follow the recommended oil viscosity for your climate, and recheck the level with the dipstick after the change to ensure proper fill.