The engine typically needs about 7.9 quarts (roughly 7.5 liters) of oil when you perform a full change with a new filter. If you drain and refill without replacing the filter, plan for around 7.0 quarts (about 6.6 liters).
What you’re asking about applies to the 2UZ-FE 4.7 L V8 that powered late-1990s to mid-2000s 4Runners (and other Toyota SUVs). Exact figures can vary slightly by model year and market, so it’s wise to confirm with your owner’s manual or a Toyota service bulletin for your specific vehicle.
Oil capacity figures by change option
These are the typical figures you’ll see cited for the 2UZ-FE 4.7 L V8, depending on whether you replace the oil filter during the change.
- With filter replaced: approximately 7.9 quarts (about 7.5 liters).
- Without replacing the filter: approximately 7.0 quarts (about 6.6 liters).
Note that variations can occur due to differences in oil filter size or regional specifications. Always verify with the vehicle’s manual for the exact capacity.
How to fill and verify oil level
If you’re performing an oil change, follow these steps to ensure you add the correct amount and verify the level accurately.
- Run the engine briefly to warm the oil, then turn off the engine and wait a few minutes for the oil to settle.
- Place a drain pan beneath the oil drain plug and remove it to drain old oil completely.
- Install a new drain plug seal/gasket if required and torque the drain plug to spec.
- Install a new oil filter, applying a light coat of fresh oil to the gasket.
- Pour in oil gradually—roughly 7.9 quarts if you’re replacing the filter; start with slightly less and add as needed.
- Check the oil level with the dipstick, adding small amounts of oil until the level reaches the full mark.
- Run the engine for a couple of minutes, turn it off, and recheck for any leaks. Recheck the dipstick again after it sits for a few minutes.
Remember: if your vehicle has a different year or market specification, the exact initial fill amount may differ slightly. Always rely on the dipstick and manual guidance.
Model-year variations
While the 2UZ-FE 4.7 L V8 is a well-known engine across several Toyota models, small variations in capacity can exist by year, region, and equipment. Some manuals may list slightly different totals or filter-related adjustments. If you’re restoring or performing maintenance on a specific year or market, consult the exact owner’s manual or a Toyota service bulletin for that VIN.
Summary
The 4Runner’s 4.7 L V8 (2UZ-FE) generally takes about 7.9 quarts of oil with a new filter, or about 7.0 quarts if the filter isn’t changed. Always confirm with your owner’s manual for your exact year and region, and use the dipstick to finalize the level after a change.