A Honda Ridgeline with the 3.5 L V6 typically takes about 5.5 quarts of engine oil when performing a standard change with a new filter. Exact capacity can vary slightly by model year and whether you drain the oil completely, so always verify with the owner's manual and recheck the level on the dipstick after filling.
Oil capacity and recommended oil for the 3.5L Ridgeline
Oil grade and total capacity
For most Ridgeline models, Honda specifies 5W-20 engine oil. The conventional total capacity for a full oil change, including a new filter, is generally around 5.5 quarts (about 5.2 liters). If you don’t replace the filter, the capacity is slightly less. Always reference the owner’s manual or the engine oil capacity sticker on your vehicle for your exact year and trim.
Year-to-year notes
Across the Ridgeline’s generations, the 3.5 L V6 has kept a similar oil capacity, with small variations by year and market. The best practice is to confirm the precise figure for your specific vehicle year and trim in the official manual or Honda’s service resources.
Oil change checklist
If you’re planning an oil change, here are the typical steps to ensure you add the right amount and use the right procedure.
- Gather supplies: 5W-20 oil (synthetic or synthetic blend), a new oil filter, a drain pan, a funnel, a ratchet/setup for the drain plug, and a new drain plug washer if needed.
- Warm up the engine briefly, then place the vehicle on a level surface and safely raise or support it if needed.
- Drain the old oil by removing the drain plug and letting it drain completely into the pan.
- Remove and replace the oil filter with a new one; lubricate the gasket with a little new oil.
- Reinstall the drain plug, then pour in roughly 5.5 quarts of oil (about 5.2 liters). Start the engine and let it run for a minute to circulate the oil.
- Turn off the engine, wait a few minutes, then check the oil level with the dipstick and top up as needed to reach the full mark.
Concluding note: While 5.5 quarts is a typical target for a full oil change with a new filter, always verify with your manual for your specific year and model, and rely on the dipstick to confirm the correct level after filling.
Model-year notes
Hydraulic and software variations do not affect the oil capacity, but some models may have slight differences in fill quantities or filter types. Always refer to the exact owner's manual for your Ridgeline’s year (2006–present) to confirm the recommended oil capacity and grade. If in doubt, contact a Honda service advisor or a qualified mechanic.
Summary
The 3.5 L V6 Ridgeline typically requires about 5.5 quarts of engine oil with a new filter, using 5W-20 oil. Check your owner’s manual and confirm with the dipstick after filling to ensure the level is correct.
Can I use 5W30 instead of 5W20 in my Honda?
Can You Switch Between 5W30 and 5W20? Only switch if your owner's manual approves. Using the wrong oil can affect engine performance and longevity. Moving from 5W20 to 5W30 adds protection but might reduce efficiency.
What kind of oil does a Honda Ridgeline 3.5 take?
0W-20 Synthetic Motor Oil Oil
Honda Ridgeline Oil Type: OE 0W-20 Synthetic Motor Oil
Oil Capacity: After draining the oil and installing the new filter, refill the motor with 5.7 quarts of oil.
How many quarts of oil does a Honda Ridgeline with a 3.5 L V6 take?
approximately 4.4 quarts
How much oil does a 2026 Honda Ridgeline need? The 3.5L V6 typically requires approximately 4.4 quarts of oil with a filter change; recommended volume can vary slightly, so we confirm the exact fill while performing service.
How to make a ridgeline faster?
Additional ways to make your Ridgeline faster and more capable include:
- Upgrading the exhaust system: Installing a performance exhaust can reduce back pressure and improve engine breathing.
- Cold air intake kits: These allow cooler, denser air into the engine, enhancing combustion efficiency.