For most Toyota 2.7-liter four-cylinder engines, the engine oil capacity with a new filter is about 6.4 quarts (6.1 liters). Always verify the exact specification for your specific model year and trim in the owner's manual or under-hood sticker.
Engine family and typical capacity
The 2.7L inline-4 commonly uses the 2TR-FE engine in models like the 4Runner, Tacoma, and Highlander. While the general guideline is around six quarts, some variations exist depending on year and whether you’re replacing the oil filter. The information below provides a concise overview.
- Oil capacity with filter change: approximately 6.4 quarts (6.1 liters).
- Oil capacity without filter change: typically a bit less, around 5.8–6.0 quarts, depending on the exact model and drain procedure.
- Common applications: 2TR-FE-equipped Toyota 4Runner, Tacoma, and Highlander with the 2.7L I4.
The figures above are typical ranges. Always confirm the exact specification for your vehicle year and model, and verify the level with the dipstick after filling.
Practical steps for oil changes
To ensure you use the correct amount and the right oil type, follow these practical steps during an oil change.
- Determine the recommended oil grade from the owner’s manual (often 5W-30 or 0W-20 for modern Toyotas).
- Drain the old oil completely and replace the oil filter.
- Begin by adding about 6.0 quarts, then check the level with the dipstick and top off as needed to reach the full mark.
- Run the engine for a few minutes, recheck for leaks, and recheck the dipstick again when the engine is cool.
In practice, starting near the high end of the recommended capacity and then topping to the correct level after the engine has run is the safest approach to avoid overfilling.
Bottom line
For most Toyota 2.7-liter four-cylinder engines, plan on about 6.4 quarts (6.1 liters) of engine oil with a new filter. Always consult your specific model/year manual and verify the level after the fill to ensure proper lubrication.
Summary
The 2.7L Toyota four-cylinder engine (2TR-FE) typically requires around 6.4 quarts of oil with a filter during an oil change. Verify exact capacity for your year and model in the owner’s manual, and always check the dipstick after refilling.