The 2022 Mitsubishi Mirage with a 1.2-liter engine typically uses about 3.0 quarts (roughly 2.8 liters) of engine oil, including the oil filter. Exact capacity can vary slightly by market, filter size, and implementation, so always verify with the owner's manual and check the level with the dipstick after refilling.
The Mirage’s 1.2L engine is designed for efficiency, and oil capacity is a common maintenance detail that can differ depending on whether the oil filter is changed and the drain procedure. The figures you’ll see in manuals and service guides are guidance for technicians, with real-world results confirmed on your specific vehicle.
Official oil capacity
The following figures summarize typical capacity values used by technicians. They distinguish between oil with the filter installed and the filter left in place, and between different markets or filter sizes. Use these as a baseline and confirm with your manual for your VIN.
- With the oil filter installed: about 3.0 quarts (2.8 L).
- Without the oil filter: about 2.6 quarts (2.5 L).
These numbers assume a full drain and replacement using a new filter. Actual fill can vary slightly depending on filter type and whether the engine is completely drained. Always fill gradually and recheck with the dipstick after the oil has settled.
Oil grade and maintenance guidelines
Oil grade and climate can influence both performance and protection. The Mitsubishi manual typically recommends the oil grade appropriate for your market and climate, often around 0W-20 or 5W-30, but you should verify the exact specification for your region and VIN.
- Cooler climates: 0W-20 is commonly recommended.
- Warmer or mixed climates: 5W-30 may be advised.
Always follow the exact grade and capacity specified in your owner's manual or by a Mitsubishi service representative. Using the wrong viscosity or capacity can affect engine protection and efficiency.
How to check and change the oil
Follow these steps to ensure you use the correct amount of oil and maintain proper engine lubrication.
- Park on a level surface and apply the parking brake. If possible, perform the change with the engine warm to help drain more oil, but avoid burns when handling hot components.
- Open the hood, remove the oil filler cap, and pull the dipstick to check the current level before draining.
- Place a drain pan beneath the engine and remove the drain plug to drain old oil completely. Allow the oil to drain fully.
- Remove the old oil filter and replace it with a new filter. Ensure a proper seal on the new filter.
- Install the drain plug securely, then pour in the new oil gradually using a funnel. Start with the baseline capacity (about 3.0 quarts / 2.8 L with filter) and stop short of full.
- Run the engine for a minute or two, then turn it off and wait a few minutes for the oil to settle. Check the level with the dipstick and top up if necessary to reach the full mark.
After completing these steps, inspect for leaks around the drain plug and filter. Proper disposal of used oil and the old filter should follow local regulations.
Summary
The 2022 Mirage 1.2 typically requires about 3.0 quarts (2.8 liters) of engine oil when changing the oil and filter. Always confirm the exact capacity and grade in your owner's manual for your specific vehicle and market, and verify the level with the dipstick after refilling. Regular checks help ensure optimal engine performance and longevity.