On a typical 2020 CR-V equipped with the 1.5-liter turbo engine, the engine oil capacity is 4.7 quarts (4.4 liters) when changing the oil with the filter installed, using 0W-20 synthetic oil.
That engine—the turbocharged 1.5L four (engine code L15B7)—uses a fairly precise amount of oil to maintain lubrication and performance. The official spec applies to US-market vehicles; owners in other regions should verify against local manuals, as regional variations can exist.
Official capacity and oil type
The official figures for the 2020 CR-V 1.5L turbo are below and are consistent with Honda's maintenance data used by dealers and service centers.
- Engine oil capacity (with filter change): 4.7 quarts (4.4 liters).
- Recommended oil grade: 0W-20 synthetic oil (Honda Genuine or an equivalent meeting API SN and ILSAC GF-5).
Note that some markets may report slightly different numbers or meet different specification standards. Always confirm with your local owner's manual or service bulletin.
Practical note: After draining the old oil and replacing the filter, add about 4.7 quarts, run the engine briefly to circulate the oil, then shut off and check the dipstick. Top up as needed to reach the full mark. Do not overfill.
Practical tips for maintenance and usage
Honda typically recommends an oil-and-filter change at intervals that vary by driving conditions, but the normal schedule for many US models is roughly every 7,500 miles (12,000 km) or 12 months, whichever comes first, with more frequent changes under severe driving conditions. Always consult the owner's manual for the exact interval for your vehicle and region.
Why getting the right capacity matters
Having the correct oil capacity ensures enough lubrication and cooling for the turbocharged engine, supports fuel economy, and preserves warranty coverage. The 0W-20 specification is chosen to balance quick circulation in cold starts with long-term protection in normal driving conditions.
Summary
The 2020 Honda CR-V's 1.5 L turbo engine takes about 4.7 quarts (4.4 liters) of 0W-20 synthetic oil, including the filter, for a standard oil change. Always verify the exact figure in your manual and use the dipstick to confirm the final level after a warm engine run.